DIY: Better Flowing Intake Box (Similar to RB Intake Box)
There are two screens in the intake box after the horn. Basically, right after the second screen lies an MAF (Mass Air Flow Sensor). You want to leave the second one, the one before the MAF, there and remove the first one. That's the one closest to the filter. 
EDIT: Renesis S3EP beat me!
I'll paste my PM answers to you on here for reference and other opinions.
Originally Posted by pm1
No, there are clips that you've got to work the plastic around to get the back end of the horn off. For me, it took some bending, scratching, and denting with a flathead screwdriver. Not easy, and I wouldn't recommend doing it more than once or twice, as you'll probably break the clips or part of the horn itself.
Originally Posted by pm2
After you unscrew the horn from the airbox, you'll notice that the horn is actually two pieces held together by clips on one end that stick through holes in the plastic on the other. It looks like it may be one piece, but if you try pulling at it from opposite directions you'll see that it's not. Once you get the horn into two pieces, you can simply pull/shake the screen out as it is just sitting between the two parts of the horn.
Registered
Joined: Sep 2007
Posts: 140
Likes: 0
aight...so i tried this..but beign as stupid as i am...i forgot to re attach the electrical wire that you disconect when modding the air box..so i started my car but it didnt start...well now i re attached it...the CEL is on...im guessing it myte dissapear sooner or later ...any thought of what it is?
Registered
Joined: Nov 2007
Posts: 213
Likes: 1
From: KY, TN border
Here's the pic.
The mod is using duct tapes for demostration purpose only. Those will probably come off under heat. I would be using some plastic plate or foam later on. Metal would absorb too much heat.
Right now I have the screens pulled off and I noticed rough idle on my car.
The mod is using duct tapes for demostration purpose only. Those will probably come off under heat. I would be using some plastic plate or foam later on. Metal would absorb too much heat.
Right now I have the screens pulled off and I noticed rough idle on my car.
Ok, I would 100% not recommend to anyone taking both screens out. I tried this 2 days ago, and it destroyed my idle, and caused my car to stall a few times. I reinserted one screen, and haven't had an issue since. DON'T remove both.
Power!!
Joined: Feb 2004
Posts: 4,412
Likes: 3
From: Sunny See attle
I'll snap his neck.
Joined: Feb 2006
Posts: 1,233
Likes: 2
From: EVOLV-Chicago
My car seems to make more power with the horn and the "noise baffles" out. Maybe if I put the horn back in and left the baffles out, I'd get more?
Pre mod, the highest GHP I saw on the scangauge was 254. Post mod, the highest I've seen is 281. Not sure how much is due to the mod, and how much is due to other factors.
Pre mod, the highest GHP I saw on the scangauge was 254. Post mod, the highest I've seen is 281. Not sure how much is due to the mod, and how much is due to other factors.
I'm not actually sure that there is a correct answer to that? For the most part, this mod is a "try and see if it causes issues or not" deal. So, if it doesn't cause you any problems then you should be fine, if it does try taking the other one out instead as thats what most have done.
Registered User
Joined: Nov 2007
Posts: 23
Likes: 0
so im pretty much a newb or w/e....ive been reading this and rereading can somebody tell me exactly how to remove the screen closest to the filter i understand its the easiest one to? i did the walls already