Cumulative Synthetic Oil Discussion
10-09-2008, 09:17 PM
#676
Here's Charles Hill holding my housings as he took my engine apart. You'll notice my housings are cleaner than either of the two photos for this oil
Engine had over 50,000 miles, with 20,000 on FI.
Last edited by mysql; 10-09-2008 at 09:23 PM.
10-09-2008, 09:21 PM
#677
I wanna rock! Rock!
Join Date: Jun 2005
Location: Monterey, CA
Posts: 576
Likes: 0
Received 0 Likes
on
0 Posts
10-09-2008, 09:24 PM
#678
Mostly royal purple .. 10w30, 15w40, anything in that neighborhood.
Then Idemitsu with FP+ for premix.
I also have the Sohn Adapter, so that feeds 2 stroke royal purple synthetic and sometimes idemitsu with regular 5w20 dino oil in there.
Then Idemitsu with FP+ for premix.
I also have the Sohn Adapter, so that feeds 2 stroke royal purple synthetic and sometimes idemitsu with regular 5w20 dino oil in there.
10-10-2008, 02:14 PM
#684
Power!!
i have a question, my rx8 was recently dynoed i have an 04 grand touring 6spd, and i got chassis dynoed by a dyna pack protable one, (yes i know they are not that accurate[/i]) but, i lost a significant amount of power. I saw online on my fone at myrotarycar.com stock was running 178.4 hp, and 134.4 torque. My numbers were quite dismal with 148 hp to 128 torque. There is oil in my intake filter, but when i took out my intake filter i was still running consistant numbers. I was told to get a compression check done, but i was told it is probably not the case, i was also told that my CAT's could be bad and are impeding flow into my exhaust so i might need a whole new cat and a catback, but i am still not able to figure out how oil is going into my intake. Can anybody help me out? Tips? Advice? I ran synthetic in my car but i called up a mazda dealership nearby and they said "run regular oil, its a rotary, just run normal 5w-20" and i told them that one of their techs told me that i could run my car on regular but the guy at the dyno said just run premium, and that I'll get better curves and it'll unclog my injectors. Heres the low down on my car.
2004 Mazda RX8 6MT
stock, except for clutchmasters FX100 clutch.
Regular gas, and synthetic (which i plan on changing to regular)
2004 Mazda RX8 6MT
stock, except for clutchmasters FX100 clutch.
Regular gas, and synthetic (which i plan on changing to regular)
Show us your dyno plot. But do it in one of the dyno threads. If your cat is clogged you'll see the hp die off above 6K rpm. If your engine is running normally you should see the power peak around 8K rpm. Ignition coils are another common problem that can lead to low power. Check out some of the other normal dyno graphs in the dyno threads and compare the curves to see if your curve is normal. If it is it's just the dyno itself.
10-10-2008, 02:21 PM
#685
11-02-2008, 08:12 PM
#691
Registered
Join Date: Oct 2008
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Great thread.
What do you all think of Pennzoil High Mileage Vehicle oil in 5W-30 for the RX 8.
Pennzoil promises the following key benefits:
That should be beneficial for the RX 8.
What do you all think of Pennzoil High Mileage Vehicle oil in 5W-30 for the RX 8.
Pennzoil promises the following key benefits:
- Active cleansing agents continuously help prevent
performance-robbing dirt and deposits from forming. - Increased viscosity and volatility control along with
seal conditioners to help lower oil consumption. - Special seal-conditioning additives help reduce leaks.
That should be beneficial for the RX 8.
11-05-2008, 08:07 AM
#693
im sure this was already adressed but my first couple oil changes i went to the dealer but after about 2500 or less miles even the oil would break completly down and foam like a ****. i was told by people its because the high rev of the car so i switched to royal purp 5-30 and had limited to no foaming at 3500 with my reg oil change. **note this was before my new engine so idk if these probs with the foam were becasue of the motor defect causin it to blow**
11-06-2008, 06:03 PM
#696
ive wanted to start pre mixin and i just looked into buyin a case of the idemitsu from mazda trix but just wonderin wat you use for a ratio and when you do it do you fill your gas tank first then put it in or what idk anythin bout pre mixin in a car
11-09-2008, 03:06 AM
#697
Lubricious
Join Date: Oct 2003
Location: SF Bay Area, California
Posts: 3,425
Likes: 0
Received 4 Likes
on
4 Posts
suck my dick 
11-09-2008, 05:00 PM
#699
what are you an english teacher? you get the point of what im saying without perfect punctuation. im a tuner not an english expert i dont think any car person gives a **** if you write perfect. i bet your an over weight 45 year old guy going threw a midlife crisis and low on self esteem so you bought a stock 8 and its gonna stay stock and you think your badass. heres a site for you to help out if the 8 doesnt work http://www.more-selfesteem.com/confidencebuilding.htm
11-10-2008, 05:22 PM
#700
Lubricious
Join Date: Oct 2003
Location: SF Bay Area, California
Posts: 3,425
Likes: 0
Received 4 Likes
on
4 Posts
im a tuner not an english expert i dont think any car person gives a **** if you write perfect. i bet your an over weight 45 year old guy going threw a midlife crisis and low on self esteem so you bought a stock 8 and its gonna stay stock and you think your badass. heres a site for you to help out if the 8 doesnt work http://www.more-selfesteem.com/confidencebuilding.htm
Nobody expects you to be an English expert. But you should show at least a little respect for the people you are writing for. Don't make them do all the work of figuring out where your sentences start and stop.
Anyway, sorry for upsetting you. Put the premix in right before you put in the gas. The flow of gas will begin to mix it.
Last edited by Nubo; 11-10-2008 at 05:35 PM.