RX8 Live!

  •   RX8Club.com


Play   Pause

EventByThread/PostForum
New Post
strokercharged95gt
07-21-2018 07:35 AM
 Thoughts on RX-9 Engine
I doubt Mazda will ever make a production rotary again. The 13b-MSP was a failure, it was a step backwards from the 13b-REW as far as durability and power. In an age where a Mustang GT can be... (303 views, 9 replies)
New Post
DannyR3
07-21-2018 07:19 AM
 Thinking of buying an rx8
How you drive it is far more important than how long you drive it. 20-30 minutes is plenty to get the engine and fluids up to temp and get a couple WOT pulls in. I put 80k miles on my 07 like that... (100 views, 1 replies)
New Thread
mazdaverx7
07-21-2018 05:44 AM
 Nordic Green Aero Parts
Looking to buy front splash guards, side aero flares, rear aero flares, front air dam, and rotor accents front and rear for my 04 in Nordic Green. Located in Ohio, zip 44089 for shipping. (84 views, 0 replies)
New Post
mazdaverx7
07-21-2018 05:34 AM
 Hoping my 8 isn't totaled.
To a fellow veteran and rotary enthusiast its the least I can do. (342 views, 18 replies)
New Post
mazdaverx7
07-21-2018 05:32 AM
 My 04 Nordic Green GT Restoration
Since I really don't know any history on the car, I called Mazda yesterday to find out what I could about the car. I did find out that the original engine lasted 75k miles and that a reman engine was... (5,987 views, 57 replies)
New Thread
Trevor Mcnutt
07-21-2018 02:57 AM
 2005 rx8 standard
2005 Mazda with no compression in the engine. Engine would run but no idle and was told the rotor seals were bad. Any other ideas on whats wrong? (92 views, 0 replies)
New Post
furansu
07-21-2018 12:07 AM
 Random OEM parts
Sent you a PM about the wing yesterday, just following up to see if it is still available. (252 views, 5 replies)
New Post
jakejm79
07-20-2018 11:12 PM
 A/C blows hot at amb temp over 98įf
I'd think if you were to wrap insulation around anything it would be from the condenser to expansion valve and expansion valve to evaporator (I.e. the small high pressure lines) that is the point... (308 views, 15 replies)
New Post
mhawk1134
07-20-2018 11:01 PM
 [NJ] 2004 6 speed Nordic Green Low miles on New engine
Any interest? (366 views, 1 replies)
New Thread
Herksr3
07-20-2018 10:38 PM
 My R3 Plans
Well it seems the Series 2 part of the forum is dead, I understand why, just thought I would let everyone know my plans for my $6k R3 Have- BHR midpipe, BHR ignition, Racing Beat Header ( all used... (106 views, 0 replies)
New Post
Oats
07-20-2018 10:34 PM
 R3 Recaros Suck!!!
Ok, I didn't realize you meant they were completely missing. I think I actually have a spare rear right insert, still new in packaging. I bought it, then realized they were all broke and decided to... (234 views, 5 replies)
New Post
swoope
07-20-2018 10:24 PM
 Hawk, Carbotech, RPF1, Car covers, high boost pulleys, water/meth, engine bay parts
anytime, i think my wack a mole issues are almost done. beers :beer: (38,200 views, 25 replies)
New Post
Oats
07-20-2018 10:15 PM
 Lowered my R3
Nope, the gap is very even. They were not made specifically for the S2. I was worried about them not coming out even but saw a few other R3s on the forums with them and it looked good so I took the... (753 views, 9 replies)
New Post
GeicoGecko
07-20-2018 10:06 PM
 What's the Chances of Needing a New Flywheel?
Thabk you! I think from there I can find the diagrams. PM me if youíre willing to look into shipping. I figure it canít hurt to see and might be cheaper :) (152 views, 6 replies)
New Post
Chrishoky
07-20-2018 09:48 PM
 Real or fake Mazdaspeed spoiler?
Agreed, looks a bit off to me from the ones I have seen. (258 views, 8 replies)
New Post
Chrishoky
07-20-2018 09:37 PM
 4g63 anyone?
Haven't ever really seen or heard of a swap with that motor, definitely not one of the more common ones which include LS, SR, or F20. (116 views, 1 replies)
New Post
Steve Dallas
07-20-2018 08:19 PM
 pics taken with borascope of rear seal leak
You are fine. It is normal for both seals to weep a bit as they break in. You can tell which one is weeping the most by smelling the joint. If it smells like sulfur, it is the transmission input... (365 views, 3 replies)
New Post
Steve Dallas
07-20-2018 08:08 PM
 "Offerup/letgo" $140 dressed mystery motor teardown & rebuild
Well, the core is worth up to $1,000, so I'd say he did OK on LetGo. (1,244 views, 42 replies)
New Post
Steve Dallas
07-20-2018 08:02 PM
 new engine worth it?
$7K?! A Mazda reman can be had for ~$3K after core exchange, if you shop around. Removal and re-installtion should not cost ~$4K. I would expect $7K to just about cover a built race engine... (194 views, 3 replies)
New Post
BigBadChris
07-20-2018 07:57 PM
 DBW Throttle body replacement found!
Interesting. I believe Team Rx8 mentioned something about the mustang throttle body when he went his quest for a metal upper intake manifold. I didn't put two and two together at the time. Nice find! (213 views, 2 replies)

All times are GMT -5. The time now is 08:45 AM.


All content Copyright © 2017 by Internet Brands, Inc.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.