slash128's Top Mount Build
#2326
Modulated Moderator
iTrader: (3)
I'm in the process of doing a new manifold too... going to use Sched 40 304SS this time and a billet divided turbo flange and a 5/8" thick engine flange.... should be stronger and keep it from cracking. Going to weigh as much as a boat anchor thoughb.. 😎
Bloody Rotary EGT's..... not kind to manifolds at all
Bloody Rotary EGT's..... not kind to manifolds at all
#2327
n3rd
Thread Starter
#2328
n3rd
Thread Starter
I'm in the process of doing a new manifold too... going to use Sched 40 304SS this time and a billet divided turbo flange and a 5/8" thick engine flange.... should be stronger and keep it from cracking. Going to weigh as much as a boat anchor thoughb.. 😎
Bloody Rotary EGT's..... not kind to manifolds at all
Bloody Rotary EGT's..... not kind to manifolds at all
#2329
n3rd
Thread Starter
A note on this reman: the whole thing looked brand new all around except for the hoist hook and the pulleys. Almost makes me want to buy another before they are gone...
The following users liked this post:
slash128 (02-25-2019)
The following users liked this post:
200.mph (02-26-2019)
The following 2 users liked this post by slash128:
RotardGuy (06-27-2019),
RotaryMachineRx (03-04-2019)
The following users liked this post:
slash128 (03-02-2019)
The following users liked this post:
slash128 (03-02-2019)
The following users liked this post:
Brettus (03-30-2019)
#2338
Registered
I totally have the chinesium version of that bov. I like how tight the piping is and the bov location keeps the throttle area open and tidy. The wrapping looks really good. Makes me wish I had just relocated my battery.
The following users liked this post:
RotaryMachineRx (04-11-2019)
#2345
Registered
I am digging the turbocharger location, though I bet it gives the alternator a hot supper. Was any other work done internally aside from milling for the deeper REW apex seals?
How much extra room did the larger MAF housing buy you before you added in the voltage divider?
How much extra room did the larger MAF housing buy you before you added in the voltage divider?
#2347
n3rd
Thread Starter
I am digging the turbocharger location, though I bet it gives the alternator a hot supper. Was any other work done internally aside from milling for the deeper REW apex seals?
How much extra room did the larger MAF housing buy you before you added in the voltage divider?
How much extra room did the larger MAF housing buy you before you added in the voltage divider?
I didn't change the MAF housing, just added the voltage divider. A bigger MAF housing was going to cost money and time but I already had the MAF extension so it was quicker and cheaper
The following users liked this post:
furansu (04-14-2019)