Williard

iTrader: (18)

Use a JIG if you can Slash but i would also suggest you have a crack at some old seals first.

You want to cut them a little at a time otherwise you run the risk of warping the metal or just plain damaging the seal.

Again, good luck to you sir. Im so excited for you lol


Travis

slash128

Agreed! Already been practicing, just not with a jig.

yomomspimp06

slash128

Go Chip!

Brettus

iTrader: (2)

Those corner seals he uses though !!!

9krpmrx8

iTrader: (46)

Is "Side Seal Clarence" his mascot?

slash128

Would you prefer something like this?

slash128

Motor is built and almost all dressed. I'll finish dressing it in the morning and then it's going back in the car....

slash128

some notes:

I hate hylomar.

The apex seal tips like to pop out when setting the center iron over the e-shaft, bastards.

I hate hylomar.

Sometimes things seem a lot easier in my head.

I hate hylomar.

I prefer driving the car to working on it.

I hate hylomar.

Williard

iTrader: (18)

Why didn't you glue the apex seals together first???

Hylomar is okay.... your okay slash.. breath. You made it.

Last but not least.

I say Good show sir!

slash128

In hindsight gluing them probably would have helped lol...

yomomspimp06

you work so fast. Good job

slash128

Thx man. I haven't driven the car in 6 weeks, I have motivation!

slash128

Ok the car is all back together, well except for the front bumper and wheels. I've been trying to start her up. I get strong even pulses on both rotors. No compression tester tho. But i pulled the plugs and and don't smell any gas on them, nor at the tail pipe. I have 55psi on the fuel gauge but it doesn't seem to be getting gas. I checked my injector connections. Is there a fuse for the injectors I'm mussiing? I can't see the forest for the trees right now so any suggestions would be appreciated.

yomomspimp06

this is under the air pump or where it once was. is it connected?

slash128

Yep my fuel pump resistor is connector. And I have fuel pressure on the gauge. Should I smell gas on the plugs? Especially after cranking on it a bunch without it starting?

yomomspimp06

something is up with the injectors firing. If there is fuel pressure then the injectors is where I would be looking. if you have been cranking for some time, I would assume there would be traces of fuel on the plugs. Is your Maf facing the correct way?

slash128

Yep MAF is facing correct way. So sad...

slash128

Ok, sanity check: which way does the trigger wheel go on, with the white paint mark towards the front of the car?

yomomspimp06

^that, I'm not sure on. I'm at work and can't go look at my car either. Sorry

slash128

No worries, appreciate you responding!

Williard

iTrader: (18)

Post a pic slash I'll compare to mine. I have no white paint mark though I know that

Travis

slash128

Thanks Travis but I just checked another hub and crank angle wheel and it can only go on one possible way. It can't even be flipped over. It's starting to act like it wants to catch but never quite does. I think I need to do a compression check before I start chasing my tail.

Williard

iTrader: (18)

A compression check will help show if you have any seals sticking. Dont take the numbers at face value just yet though. Break in and all yet....

Injectors wires are correct? Ess is plugged in?

Travis

slash128

ESS is connected. I double checked injector wires with pictures I took during tear down. It seems like it might want to catch but just doesn't.