dpmdc

New factory rx8 reman. Braking in slow and steady and all went well until we crossed over to 6500 rpm. Now it misfires and leans out. Replaced all fuel injectors and richened load and still some leaning out. Any suggestions?

9krpmrx8

iTrader: (46)

Why did you replace all the fuel injectors and how did you "richened" the load?

dannobre

iTrader: (3)

Tell us the rest of the story

dpmdc

First assumption was bad secondary injectors or no signal to them. I haven't checked them with a noid yet.

Before replacing all 6 injectors I tweaked the ECU maps and that made absolutely no difference.

while replacing them yesterday I did find a kink in the fuel line that runs between the primary and secondary fuel rails. I fixed that and that seemed to have helped.

I need to go back now and reset the ECU to the previous settings.

Engine sounds and feels much stronger so I think the fuel line may have been the culprit. We are now getting larger flames from the exhaust (we use pre mix 1.5 oz. / gallon of gas) than we usually do.

Not much else I can think of that would cause the issue. If so please enlighten me.

dannobre

iTrader: (3)

Kinda a no brainer.....this likely was your problem

No fuel supply = lean