Using RX7 plugs without shims
11-14-2010, 01:21 PM
#1
Using RX7 plugs without shims
The 2004 model 8 that I recently purchased used was running RX7 plugs -NGK BUR 9EQ in the trailing position without use of shims. These plugs are about 3mm longer than oem plugs so hence need for the shims..
What damage if any could this have caused to my engine ?
Read somewhere that the longer RX7 plug presses against the engine housing and can cause it to deform over several heating cycles leading to low compression in the engine.
What do you guys think ?
What damage if any could this have caused to my engine ?
Read somewhere that the longer RX7 plug presses against the engine housing and can cause it to deform over several heating cycles leading to low compression in the engine.
What do you guys think ?
Last edited by bixx66; 11-14-2010 at 01:32 PM.
11-14-2010, 01:23 PM
#2
Registered User
Join Date: Sep 2010
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Not sure why the owner would possibly do that to the engine, regardless of what effect it has. The series 2 ignition system is very strong, and would be greatly reduced by old RX7 plugs.
I would get that replaced immediately.
I would get that replaced immediately.
Thread
Thread Starter
Forum
Replies
Last Post
JimmyBlack
Series I Major Horsepower Upgrades
273
02-10-2020 10:23 PM
Fickert
Series I Major Horsepower Upgrades
7
09-09-2015 01:21 PM
