Notices
Series I Major Horsepower Upgrades This is the place to discuss Super Chargers and Turbos, Nitrous, Porting, etc

Carbon8 Build

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 07-18-2013, 10:38 AM
  #251  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Any idea on the whiney sound before I start the car, thats the one I don't recognize.

Although its been about 10 months so Its probably a normal sound I just don't remember it.

FYI this was a hot start, but it makes the sound regardless. Its not the TB, ABS or air pump I do know that.
Old 07-18-2013, 10:42 AM
  #252  
SARX Legend
iTrader: (46)
 
9krpmrx8's Avatar
 
Join Date: Jan 2007
Location: San Antonio, Texas
Posts: 33,784
Received 452 Likes on 366 Posts
That is normal start up check procedure, I believe it's the throttle body.
Old 07-18-2013, 10:45 AM
  #253  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
IRC the TB sound is not constant, its checks position and movement and then stops. this is a constant sound, even with the engine on it is still present just not really noticeable over the CAI
Old 07-18-2013, 11:55 AM
  #254  
WENTGERMAN
iTrader: (6)
 
shadycrew31's Avatar
 
Join Date: Apr 2008
Location: Burbs,PA
Posts: 5,805
Received 30 Likes on 22 Posts
The TB is always humming before starting the car, it'll hum for hours until the battery dies.
Old 07-18-2013, 11:57 AM
  #255  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Figured it was normal, Just couldn't remember.

So first day driving it and with less than 10 miles on the new motor, I have my first ticket

Either a record or a great kickoff to this season.
Old 07-18-2013, 12:28 PM
  #256  
WENTGERMAN
iTrader: (6)
 
shadycrew31's Avatar
 
Join Date: Apr 2008
Location: Burbs,PA
Posts: 5,805
Received 30 Likes on 22 Posts
Originally Posted by Carbon8
Figured it was normal, Just couldn't remember.

So first day driving it and with less than 10 miles on the new motor, I have my first ticket

Either a record or a great kickoff to this season.
Did you tell him you were breaking in a new engine?

That excuse worked for me once.
Old 07-18-2013, 12:41 PM
  #257  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
I was granny driving, he complained about my exhaust.

My response was "I barely put 5,000 miles a year on this car, I am not changing it"

He gave me a warning and then said "Nice Car"
Old 07-18-2013, 12:54 PM
  #258  
Registered
 
abesRX8's Avatar
 
Join Date: Feb 2008
Location: Chattanooga TN
Posts: 35
Likes: 0
Received 1 Like on 1 Post
Originally Posted by Carbon8
I was granny driving, he complained about my exhaust.

My response was "I barely put 5,000 miles a year on this car, I am not changing it"

He gave me a warning and then said "Nice Car"
Yep the sound is normal... Mine is just as loud.

I have had this happen too... but you got lucky with a warning.
Cop pulled me over for 11 over, after I sign the ticket he proceeds to say " really nice car man, what all you have done to it" I gave him an eat **** look and said "enough".. He said "ok" and walked away....
Old 07-18-2013, 12:58 PM
  #259  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Ill take the tickets, Im not changing my car. Besides I know almost all the D/A's around and they get dropped or turn into 40 dollar parking tickets. I could care less! The only time I change is I put my CAT on once a year for inspection.
Old 07-18-2013, 03:52 PM
  #260  
Registered
 
Usbraz1's Avatar
 
Join Date: Apr 2013
Location: Vancouver Wa
Posts: 27
Likes: 0
Received 0 Likes on 0 Posts
You should do a post with all the parts and cost, awesome build btw!!
Old 07-18-2013, 06:04 PM
  #261  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
You don't want to know the cost

The more I look at it the more depressed I become!
Old 07-18-2013, 06:51 PM
  #262  
WENTGERMAN
iTrader: (6)
 
shadycrew31's Avatar
 
Join Date: Apr 2008
Location: Burbs,PA
Posts: 5,805
Received 30 Likes on 22 Posts
Originally Posted by Carbon8
You don't want to know the cost

The more I look at it the more depressed I become!
When you own a turbo double everything....
Old 07-18-2013, 07:36 PM
  #263  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Ill post it up tomorrow it's on my computer at the office, this build will rival FI.
Old 07-19-2013, 07:50 AM
  #264  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Round 2


Its noticeable more towards the end, it sounds like a trashed pilot bearing but only does it when in gear and under load. Going to take my syncro saver off later tonight and see if they are just vibrating against each other. When I push the shifter down slightly the noise disappears.

I have narrowed it down to either the syncro saver or the axial flow shifter, which I noticed has a lot more backlash on the s2 than on my s1 version which might be coming into play also.
Looking for some outside opinions on this one.

Also took her for a 250 mile cruise out to the lake yesterday, A/F seems lean at 14.2:1 I did see some spikes around 11:1 also. Not sure if this is normal.

I know their are a lot of different break in procedures, I am basically just taking her easy until 500 miles, then oil change, then will continue normal (not aggressive) driving untill 1000 miles. Then I will consider it broken in. At that point in time I assume its good enough to go for a dyno day. Considering that I have a lot of miles planned this weekend I might be able to get a pull or two by the end of next week!

Old 07-19-2013, 08:46 AM
  #265  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
For those that asked for it, hears everything I consider to be into mechanical only.

Note some stuff was added before this build (exhaust and clutch).




Now show me a straight face and tell me I couldn't have gone SC for the same or cheaper!
Old 07-19-2013, 09:02 AM
  #266  
No respecter of malarkey
iTrader: (25)
 
TeamRX8's Avatar
 
Join Date: Apr 2005
Posts: 26,727
Received 2,011 Likes on 1,639 Posts
Originally Posted by Carbon8
this build will rival FI

did you miss the memo about never going full ret@rd?
Old 07-19-2013, 09:04 AM
  #267  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Not following, this build does rival an FI for cost. I was aware of that from day one and could care less. Not sure what you are getting at other than an unnecessary statement.
Old 07-19-2013, 09:15 AM
  #268  
Modulated Moderator
iTrader: (3)
 
dannobre's Avatar
 
Join Date: Feb 2004
Location: Smallville
Posts: 13,718
Received 334 Likes on 289 Posts
You paid $620 for ignition wires ?
Old 07-19-2013, 09:19 AM
  #269  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Haha, bad descriptions. LS2 coils, wires and NGK plugs was what that was for to be specific!
Old 07-19-2013, 09:35 AM
  #270  
SARX Legend
iTrader: (46)
 
9krpmrx8's Avatar
 
Join Date: Jan 2007
Location: San Antonio, Texas
Posts: 33,784
Received 452 Likes on 366 Posts
Did you get your series II transmission brand new?
Old 07-19-2013, 09:45 AM
  #271  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Yup, By the time I found one used, paid for shipping. then realized it probably needs a rebuild. Then realized Mazda can't rebuild a trans fro Sh*t. It was the best option. If you are asking about the price.

If you are referencing the video, My only concern is 1.5 quarts seems low for this trans, the fill plug is not even halfway up it and you can fill threw the shifter. Seems contradictory!
Old 07-19-2013, 09:52 AM
  #272  
SARX Legend
iTrader: (46)
 
9krpmrx8's Avatar
 
Join Date: Jan 2007
Location: San Antonio, Texas
Posts: 33,784
Received 452 Likes on 366 Posts
Yeah i was referring to the price. I was hoping you didn't pay that for a used one.
Old 07-19-2013, 10:01 AM
  #273  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
Yeah, No.....

That's the price brand new with shipping from CA to NY
Old 07-19-2013, 11:37 AM
  #274  
WENTGERMAN
iTrader: (6)
 
shadycrew31's Avatar
 
Join Date: Apr 2008
Location: Burbs,PA
Posts: 5,805
Received 30 Likes on 22 Posts
I only buy used parts, except for engine parts and turbo parts.
Old 07-19-2013, 01:04 PM
  #275  
Yank My Wankel
Thread Starter
iTrader: (4)
 
Carbon8's Avatar
 
Join Date: Nov 2009
Location: Buffalo, NY
Posts: 2,207
Likes: 0
Received 6 Likes on 6 Posts
transmission connected to the engine, thats an engine part


You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: Carbon8 Build



All times are GMT -5. The time now is 12:56 PM.