i've been on the internet for 4 hours searching for this but i still cant find someone who has them in stock and sells them i've seen some but they look ugly and they cost like $300 wtf so can someone help me or redirect me to a thread that i have missed thats answers my question

 

renesisSE3P has a guage pod setup similar to that, ask him

 

thanks

 

you can get it at rx8strakes.com

 

^they only sell the lotek type of gauge pod that goes on top, and its more expensive on their site.

http://www.gaugepods.com/mazda.html

 

The picture he showed was of the lotek pod... which your right, it does go on top. You can also find it occasionally on e-bay, that is where I got mine.

 

^^ thanks i'll check ebay i dont feel like spending more than $100 on this

 

n rider 89 thanks ima be buying them from there.just wondering what are the clamps for what do you clamp them to?

 

After you remove your center dash piece you need to cut a hole in it. You then glue the pod to it and clamp it down until the clue drys. It will look like this when done.

 

damn that looks so nice so these gauges do they read for example fuel/voltage w some wire that goes to the source or a signal

 

hey i just noticed u have something connected to the airbag light

 

airbag light? looks like a cigarette lighter...

 

yeah on my 8 thats the airbag light for the passenger side it lights up saying airbag off when a certain amount of weight is on it i think if its under a hundred pounds

 

before 06 at least in the states in the it was just a circle in the dash

 

Yes, it is just an accessory plug for the radar detector... haven't gotten around to hard-wiring it yet. The gauges I got are oil pressure, oil temp, and coolant temp. The gauges are from prosport, which many on the site have. I looked at past transactions and lotek on ebay login name is lotekengineering. The gauges are from http://prosportgauges.com/.

 

i would get the voltage/fuel and the third im still deciding our car already has an oil pressure gauge and temp.so what do you guys think my third should be?

 

^ don't rely too much on the stock gauges. they aren't very accurate -- especially the oil pressure gauge

 

^ yeah my oil pressure one has always been in the same place a lil over the middle hopefully thats a good thing lol

 

All that shows is if you've got pressure or not.... I like watching mine bounce up and down w/ the throttle.

 

^ haha thats bada$$ ima get the oil pressure gauge for my third then....one more thing on a scale from 1-5 how hard is the install im asking cuz im afraid of doing anything that includes cutting or making holes in my car

 

For me about a 3. My temperment isn't suited to this time consuming task...... at times I just wanted to use a hammer. It is just basically pulling wires and keeping them straight, but I read through other install threads to find the wires to tap. GL w/ your install.

 

so these are the 52mm right?