Cool man - good luck.

 

I'll start playing with this in May when you have the MAF tuning incorporated.

 

hey was up kane you in FL yet or what??

 

I leave in like 5 days...

Then I'll be in FL.

Beta testing the auto-MAF tool right now with J.Cab

 

how's it going?

 

Gonna be a delay on the MAF tool - it works...but not the best way possible.

It will be out by the end of May.

 

cool. subscribed.

 

cool let me know i'm about 1 hour away from where your going

 

I have Half of the MAF Tool done - kinda behind... I need to change the entire software to be load based compatible.... so if I am not too slammed I should have it out in a few more days.


PS - The upside is that it is really easy to do.... even easier than my old beta.

 

look at this every day till it's done.

there's no working version of baseline available to the public at this time.

 

Closer..... I am halfway through the code.....

 

Done... version 1.5 is getting loaded to the website now...

 

Sweet Nicely Done

 

HH - are you going to play with it today?

I can email you a copy while I wait around for the server to get up if you wanna start.

 

That sounds good man.

 

I don't see it there

 

i think its still uploading

 

Updated first post - my website is still being slow and annoying - so just download it from here.

I will type up the "how-to" in a second.

 

I know - patience is a virtue... LOL

 

Ok; everyone go and read my MAF Tuning sticky here: https://www.rx8club.com/series-i-engine-tuning-forum-63/how-scale-your-maf-flash-tuning-cobb-hymee-169597/

The new version of Baseline does the same thing only automatically.

So step one is to set up your car in Baseline ***IMPORTANT: ODBII ONLY LOGS ONE INJECTOR - YOU MUST ONLY SET UP ONE INJECTOR!!!!!!!!!! Set up one big injector if you want.... 280+380+380cc's for stock.***

Then set up your scales (use the ones in cobb or hymee's tool) - and set up your target AFR's (again just copy the ones in your EMS).

OK; so once that is done when you drive and log (long slow pulls just like the sticky) - and select the MAF Scale button you can see the M-Values based on MAF Voltage OR go to the View My Tune information to see more details like AFR, Load Etc....

Make the % changes needed (or just multiply the original values by the M-Value) and reload and re-tune.

Be sure to reset the Fuel trims and or ensure you are not in closed loop; there are too many ways to go about this so I won't really comment too much about style points....

However; with warmed up car and flashed fuel trims - the scaling does work fine as long as your not waiting to log - IE log before you build fuel trims. Or just make sure your in open loop.

 

It's still early...LOL

 

No one is allowed to yell at me for setting up the Target AFR map.... it sucks I know..... but you only have to do it once!

 

PS - READ THE HELP FILE!!!! This is not a toy; you need to sit down block out some time and set up your motor properly the first time. Otherwise you are going to have problems.

But again - once you set it up you're done, and tuning with it is very fast.

 

woohoo! now if it would just stop raining long enough for me to do about 30 logs, i can get started.

 

Weird that it would rain in Florida during the summer..... hmmm