Front Plate has to go!!!!
#26
Black Ace
Thread Starter
Join Date: Oct 2003
Location: Singapore (EAST)
Posts: 841
Likes: 0
Received 0 Likes
on
0 Posts
Mster - U do not need to remove the bumper. Just simple 3 nuts (phillips) for mine. Base plate differs from PIs i guess.
Mine has two infront and 1 behind the mesh but easily reachable by hand via the openings just below.
Mine has two infront and 1 behind the mesh but easily reachable by hand via the openings just below.
#27
Registered User
Join Date: Jul 2003
Location: Singapore
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
Hi Neon,
Sorry, only ready yr message. FYI, I've hesitated to remove the logo bcos U need twice the paint work to cover smoothly. If u putty the holes....they will sink after awhile...then U need to putty again. & of course U need to spray the entire piece to aovid any fading shades..
Now, still quite happ with my GDB GT wing with front lips & back lower bumber spray painted.
cheers
Sorry, only ready yr message. FYI, I've hesitated to remove the logo bcos U need twice the paint work to cover smoothly. If u putty the holes....they will sink after awhile...then U need to putty again. & of course U need to spray the entire piece to aovid any fading shades..
Now, still quite happ with my GDB GT wing with front lips & back lower bumber spray painted.
cheers
#28
Originally posted by Neon
Ok just did mine. Note it definitely fails VICOM. Moreover mine is white backgrd--->worse (on Black 8)
Apologies for the pix, taken with V200. :D
Ok just did mine. Note it definitely fails VICOM. Moreover mine is white backgrd--->worse (on Black 8)
Apologies for the pix, taken with V200. :D
#30
Registered User
Join Date: Aug 2003
Location: Everywhere
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
From my personal exp, yes sticker fails Viacom though you might not fail the whole inspection. My inspector was nice enough to just tell me remember to bring my front plate next time (realy forgotten abt it) and bolt it on before the inspection.
Hope this helps.
Hope this helps.
#31
Black Ace
Thread Starter
Join Date: Oct 2003
Location: Singapore (EAST)
Posts: 841
Likes: 0
Received 0 Likes
on
0 Posts
Agree. My EG9 had the same problem. However, my inspector told me go change and then come back. So what i did was drove out park at the side and screw on my original standard plates. Smoked a couple n drove back in.....PASS :D
Hope this helps too..... =_=)V
Hope this helps too..... =_=)V
Thread
Thread Starter
Forum
Replies
Last Post
JimmyBlack
Series I Major Horsepower Upgrades
273
02-10-2020 10:23 PM
Touge
Canada Forum
0
09-18-2015 12:21 AM
Fickert
Series I Major Horsepower Upgrades
7
09-09-2015 01:21 PM
projectr13b
Series I Do It Yourself Forum
1
09-06-2015 01:04 PM