Wiring PAC RP4-MZ11
#1
Registered
Thread Starter
Wiring PAC RP4-MZ11
Hi everyone,
I bought an RP4-MZ11 and a Kenwood DPX303MBT. I figured most of the wiring with the manual except these:
RP4:
- Blue/White - Amp Turn On Input
- Blue - Antenna On Input
Kenwood:
- Blue/White - Antenna Control/Power Control
Does this mean I have to connect both wires from the RP4 in the 1 from the HU, or just one of them and leave the other hanging?
I bought an RP4-MZ11 and a Kenwood DPX303MBT. I figured most of the wiring with the manual except these:
RP4:
- Blue/White - Amp Turn On Input
- Blue - Antenna On Input
Kenwood:
- Blue/White - Antenna Control/Power Control
Does this mean I have to connect both wires from the RP4 in the 1 from the HU, or just one of them and leave the other hanging?
#2
Registered
Thread Starter
To answer my own question for posterity: Both wires from the RP4 connect to the same wire in the HU.
Now I just have to find a way to get to that freaking side bolt...
Now I just have to find a way to get to that freaking side bolt...
The following users liked this post:
lunarx (07-11-2020)
#3
Just adding a note here for reference in case anyone else is installing a Kenwood in their RX-8.
I'm installing a Kenwood DPX505BT Bluetooth receiver in my 2009 RX-8 (also using the PAC RP4-MZ11 interface), and the radio harness that came with the Kenwood has a brown MUTE wire. I could not find a corresponding MUTE wire on the RP4-MZ11 harness so I called Crutchfield (where I purchased everything), and they confirmed that the MUTE wire from the Kenwood harness is just left unconnected.
I'm installing a Kenwood DPX505BT Bluetooth receiver in my 2009 RX-8 (also using the PAC RP4-MZ11 interface), and the radio harness that came with the Kenwood has a brown MUTE wire. I could not find a corresponding MUTE wire on the RP4-MZ11 harness so I called Crutchfield (where I purchased everything), and they confirmed that the MUTE wire from the Kenwood harness is just left unconnected.
Thread
Thread Starter
Forum
Replies
Last Post
Vorsanss
Series II Interior, Audio, and Electronics
26
06-17-2016 12:44 AM
andrewhelmus
Series I Interior, Audio, and Electronics
1
03-28-2014 08:25 AM