Wiring PAC RP4-MZ11
Hi everyone,
I bought an RP4-MZ11 and a Kenwood DPX303MBT. I figured most of the wiring with the manual except these: RP4: - Blue/White - Amp Turn On Input - Blue - Antenna On Input Kenwood: - Blue/White - Antenna Control/Power Control Does this mean I have to connect both wires from the RP4 in the 1 from the HU, or just one of them and leave the other hanging? |
To answer my own question for posterity: Both wires from the RP4 connect to the same wire in the HU.
Now I just have to find a way to get to that freaking side bolt... |
Just adding a note here for reference in case anyone else is installing a Kenwood in their RX-8.
I'm installing a Kenwood DPX505BT Bluetooth receiver in my 2009 RX-8 (also using the PAC RP4-MZ11 interface), and the radio harness that came with the Kenwood has a brown MUTE wire. I could not find a corresponding MUTE wire on the RP4-MZ11 harness so I called Crutchfield (where I purchased everything), and they confirmed that the MUTE wire from the Kenwood harness is just left unconnected. |
All times are GMT -5. The time now is 11:40 PM. |
© 2024 MH Sub I, LLC dba Internet Brands