what size of spacers would i need? Do spacers have anything to do with bolt pattern? My question is what size would i need in order to run the following setup: Racing Hart CXR in matte black. The fronts are 19X8.5 (+38 offset) and the rear is 19X10 (+44 offset). 5X114.3 PCD. I currently have a 09 R3 and the bolt pattern is 5 x 114 will this fit?

 

Should fit great...no spacers needed

 

post in the will it fit thread but I'm thinking you might need a fender roll. especially if your lowered

 

Are u sure that rim can fit even if the bolt pattern is off by .3?

 

the rx8 is 5x114.3

 

Well I think that they would fit on there but I doubt that its good to run those wheels. Again I would check with someone else.

 

Bolt pattern has nothing to do with offset. 114 is just short for 114.3. Your rx8 is 114.3, along with most other cars except for Euro's which have 112.

Those wheels will fit fine unless you have some real wide tires in the back (275+), then you might have to roll the fenders.