Just put some oil in and did my math wrong. I haven't turned the car on yet. Any suggestions on the easiest way to remove some oil? I don't have access to a ramp without driving somewhere.

Here is where my oil line on the dip stick is.

 

I would just jack it up and unscrew the drain pug let a little oil out then put the plug back in. Your going to get covered in oil but better then blowing a seal

 

I don't exactly see how it will blow a seal? Worse I think will happen is a blow-by in the intake and dirty up your MAF sensor messing up the readings. Unless you have an oil catch can, I would try to not redline it as much causing the oil to go into your intake manifold(follow the hose connected from your filler cap and you'll see what I mean). Besides, that is what the OMPs are for!

 

It will be fine there.......

 

I did the same thing last oil change . Just made sure i did not give it the beans until the level had come down a bit. I think you should be fine with that.

 

Just drain some out its not rocket science.

 

A fluid vac is a great investment. You can suck out some oil or all of it.