I'm about to change out the injectors in my car again for aftermarket one's, and since the connectors are different, I would have to splice or cut the wires so the retaining clips (connectors) will fit with the harness.

So I'm just wondering if anyone knows a place that sells injector clips with a male connection to the stock retaining clips for a clean install with no soldering and an easy disconnect if I choose to go back to stock

 

Oh boy. Atpturbo sells the connectors.

 

you might try to see if you can de-pin from the OE connector and then slide them in to the alternate one, just depends which one you will be using and if the pin type/size is close enough to each other, most sell direct plug & play adapters for all the popular stuff too


.

 

You can buy adapters for almost anything to almost anything....

try Ballenger Motorsports I have had good service from them in the past

 

Can someone please confirm which one I would need? I believe it's the Denso type, but I still can't find any male connections - or maybe I'm blind?

http://www.bmotorsports.com/shop/ind.../cPath/109_175

 

BUMP!

OR any of these connectors are proper for the rx8? I really want to be sure before purchasing and any help is greatly appreciated

http://www.atpturbo.com/mm5/merchant...egory_Code=FUL