Engine Longevity
#1
Registered
Thread Starter
Engine Longevity
So, I've got a Mazda remanufactured engine and I want to extend its' live as long as possible.
I've got the omp setup to inject 2 cycle oil.
I'm also premixing every fillup.
I'm running upgraded ignition coils.
Is there anything I'm missing?
I've got the omp setup to inject 2 cycle oil.
I'm also premixing every fillup.
I'm running upgraded ignition coils.
Is there anything I'm missing?
#2
FULLY SEMI AUTOMATIC
iTrader: (9)
get rid of the cat. other than that its a crap shoot
The following users liked this post:
RX0004 (11-20-2018)
The following users liked this post:
Sydo (11-21-2018)
#8
Registered
Thread Starter
I got a BlueTooth scanner - Torque. Though, I haven't tried monitoring the fuel trims. I'll look into that. I've got a water temp gauge to keep a constant eye on that.
#9
Registered
Thread Starter
Then I found a post by rotaryresurrection I think. It seems that in an effort to better deal with more and more restrictive emissions standards, the later roatary cars injected less oil-which would increase wear and contribute to or cause loss of compression, loss of power, hot starting issues, etc.
I've been premixing only (deleted omp) on the rx7 for a little over 10 yrs and have had no internal wear-related issues.
I'm gonna try premixing in the rx8 -- also gonna look into if it;s possible to up the amount of oil injected by the omp.
#10
Boosted Kiwi
iTrader: (2)
Do mod no2 and you wont need to premix : https://www.rx8club.com/series-i-tec...9/#post4872229
Thread
Thread Starter
Forum
Replies
Last Post
mikefives
Series I Aftermarket Performance Modifications
6
01-23-2011 06:21 AM