Anyone have anythng that bonds to plastic of UIM?
Thread Starter
Modulated Moderator
iTrader: (3)
Joined: Feb 2004
Posts: 13,720
Likes: 345
From: Smallville
Anyone have anythng that bonds to plastic of UIM?
Anyone know if JB Weld sticks to the UIM well??
Anything else that works?
I want to put my IAT sensor in the manifold......
Anything else that works?
I want to put my IAT sensor in the manifold......
I'm sure any type of high heat two part epoxy would work.
Or my favorite Marine Tex
We use to fill the intake ports in our Peripheral Port Rotaries with this stuff. Never and issue.
Go to a Marine Supply Store for it.
I actually plugged a hole in an engine block with it once. It worked out well. Amazing stuff. Stronger than JB Weld!
Or my favorite Marine Tex
We use to fill the intake ports in our Peripheral Port Rotaries with this stuff. Never and issue.
Go to a Marine Supply Store for it.
I actually plugged a hole in an engine block with it once. It worked out well. Amazing stuff. Stronger than JB Weld!
U-Stink-But-I-♥-U
iTrader: (1)
Joined: Mar 2005
Posts: 2,004
Likes: 2
From: 12 o'clock on the Beltway.
I second a good 1:1 epoxy.
Off topic.
Where is the stock IAT sensor?
I have been data logging boost runs ant the IAT just sits there.
Yes, i suppose I could do a search.
Off topic.
Where is the stock IAT sensor?
I have been data logging boost runs ant the IAT just sits there.
Yes, i suppose I could do a search.
Thread
Thread Starter
Forum
Replies
Last Post
JimmyBlack
Series I Major Horsepower Upgrades
273
Feb 10, 2020 10:23 PM
1.3_LittersOfFurry
Series I Trouble Shooting
9
Sep 22, 2015 01:54 AM
projectr13b
Series I Do It Yourself Forum
1
Sep 6, 2015 01:04 PM
