Built a couple turbo cars before. New to these Rotary engines, and looking to buy a RX8, I was thinking of Turbo a RX8, only plaining on running 7 - 8 psi, just wondering if that would be to much boost for a stock Rotary and too hard on the seals, Also how will the injectors and fuel pump keep up. Newbee questions but wouldn't mind some help

 

that's fine as long as you don't run lean for any reason - the Renesis seals will take a little abuse but not much in comparison to a piston engine .
Many turbo owners are now moving to stronger seals .

 

Is it nesasary to put a bigger rad in it? also for the tunning and computer can i just use the Cobb Accessport, Should I do anything with the mass air and intake temp sensor. Do you guys use the GM 4 bar map sensor

 

you need to read the stickies at the top of this forum

 

this is a maf based car..AP to tune....in this car a bigger RAD is a good idea turbo or not LOL....

3mm apex seals FTW!!!