Which Greddy Upgrade is this?
#4
Actually, I don't think this is BNR, my turbo has 12 turbine blades, not 11
http://gonzaloherrero.com/bnr/index....d=82&Itemid=86
http://gonzaloherrero.com/bnr/index....d=82&Itemid=86
#7
the original owner didn't say so I assume he didn't know since he installed the turbo kit and forgot the rag in the intercooler and then couldn't figure out why it would not start
The inlet is 53mm
I thought it was stock too until I showed it to Dave @ KDR .... and he said it's an upgrade
The inlet is 53mm
I thought it was stock too until I showed it to Dave @ KDR .... and he said it's an upgrade
#8
#12
Ok so upon closer inspection of the turbo I found some more clues ... The number on the turbine side has 2 numbers shaved and restamped .... it reads 179-10300 ... where the bold ones are the ones that look like they were shaved
also the 30 looks really fresh so the 1 and 9 could be on the stock greddy unit as well? Someone please confirm....
The cartridge has Z3 stamped on one side and K3 stamped on the other
Brettus, could you link me to the thread about the pros/cons discussion of that?
also the 30 looks really fresh so the 1 and 9 could be on the stock greddy unit as well? Someone please confirm....
The cartridge has Z3 stamped on one side and K3 stamped on the other
Brettus, could you link me to the thread about the pros/cons discussion of that?
Last edited by stinksause; 10-14-2010 at 06:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post