Wiring to ignition source?
#5
Danny Rotstein
Thread Starter
iTrader: (10)
Join Date: Dec 2009
Location: Chicago
Posts: 1,325
Likes: 0
Received 0 Likes
on
0 Posts
I tried searching, it was hard to distinguish what was accessory vs ignition.
I think wiring to the power of "room fuse" would be my best best. Is that under the hood or in the cabin? (sorry not by my car atm)
I think wiring to the power of "room fuse" would be my best best. Is that under the hood or in the cabin? (sorry not by my car atm)
#9
Danny Rotstein
Thread Starter
iTrader: (10)
Join Date: Dec 2009
Location: Chicago
Posts: 1,325
Likes: 0
Received 0 Likes
on
0 Posts
I'm pretty sure it comes with a fuse in the wire I have to put to the ignition source. I wouldn't "fuse tap" ever lol. I would use one of those non-cut splices I think where I just put the two wires next to eachother and clamp down.
#10
User and Abuser
iTrader: (3)
If you don't want to solder, fine. But use 3M 33+ tape and run a zip tie around it to keep the tape from ever unraveling. And before anyone says anything, again, you can't use heatshrink on a wire that's connected at both ends.
Thread
Thread Starter
Forum
Replies
Last Post