i have a Kicker ZX750.1, but i seem to have misplaced the bass **** that came with it. i want to have something a little more stealthy mounted in the switch panel where the DSC off button is. is there any way i can get another potentiometer to do this. the one that came with my amp plugged in using a phone type cord, which seems like that could be a problem. any help would be appreciated.

 

you should be able to pick up the remote **** that kicker makes pretty cheap. and you can put it where you want very stealth like... just open the box hack the scrap off the printed circuit board and drill a hole for it

i'm sure it can be done other ways, but unless you have ideas and details worked out, you'll prolly be cheaper to just buy original equipment

 

jacked this pic from Jedi's thread. i want something that looks like this. the one that came with it will not mount anything like this.

 

Hey nuke. I can't imagine that the pot will not come out of the housing for a stealthy mount. A quick ebay search came up w/ about 5 of them for less that $10.00

Doyle

 

Hey nuke did you find your bass **** cus I got one at the shop...



KIlinm you going to spring break nat. In daytona at the ocean center?Im going
tom R o

 

Nuke, this is the **** that comes with the kickers... MY **** looks EXACTLY like Jedi's.... think out side the box man... pop open the box.... and cut down the PCB inside... just like i told you, thats what Jedi did, i know for a fact.

 

Sorry for posting on a old thread...
Can someone post here or mail me the internals of the kicker bass **** zx series please ?
along with the circuit diagram and component details and the wire colour code of the bass **** wire !
I wanna make one for my zx1000 amp
Thanks

 

Nobody here is going to have that information man. I doubt you'll find that from anywhere except Kicker themselves....and they're not going to tell you.

Just buy the Kicker bass **** for any of their amps. They're all the same. In fact, most any bass **** for any amp would probably work fine.(I have seen different connectors, but the same in general) I installed mine exactly as discussed/pictured above. Pop open the casing around the PCB and cut it down to size. You can easily see the outside edges of the PCB are not in use.