grodriguez

I've purchase a heavy duty clutch set from SR MotorSports for my RX8; and after the installation, there is a rattle sound when I place a gear and running in any gear.

Has anybody installed that clutch and got the same rattle noise? I bought the blue workshop manual for RX8 for the installation and used all the tools for the installation (pilot removal kit, pilot installation tool, flywheel stopper and alignment tool).

I appreciate all you guys input.

grodriguez

"Heavy Duty Cluctch Set" that is the name of the clutch; I think that they manufacture it. I've sent a email to them and when I get a response I'll post it for your guys info in case someone will have the same issue as I did.

Thank you.

grodriguez

This is part number I ordered it and installed: RE-13120HD

You can see it on their website: http://www.srmotorsports.com/RX8_Clutch_Flywheels.html

Thank you,

grodriguez

I have contact them by email, and I have not received a response yet.

I'll try to call them today.

Regards,

speedracer40

I have installed the same clutch system. So far have been running over 6 months with no probs. That rattle noise might be your throw out bearing...did you change this and did you add high temp grease as instructed?

grodriguez

I have installed the same clutch system. So far have been running over 6 months with no probs. That rattle noise might be your throw out bearing...did you change this and did you add high temp grease as instructed?

Yes, I did and yes I apply high temp grease. I followed step by step on the manual to install it. That is why I don't understand why the rattle noise.

What I think that I have to do is to check the clutch and flywheel again. That is the only way to find out where that noise is coming from or what is going on.

Regards,