REVi Intake Installed--First Impressions
04-11-2006, 12:00 AM
#78
Im trying to understand how they're re-using the OE screen assembly, the typical aftermarket MAF tubes are 3.5" OD i.e., AEM etc., but the OE screen frame is roughly 3.75" OD. I don't want to damage or modify the OE screen for a custom intake system. I saw a pic that looked like maybe RB had a sleeve that the OE screen slipped into, which then clamped onto the two tube ends.
the simple solution for me is probably just to buy similar sized hardware cloth, wrap it around the tube end, slide a silicone hose coupler over it, and clamp it down.
the simple solution for me is probably just to buy similar sized hardware cloth, wrap it around the tube end, slide a silicone hose coupler over it, and clamp it down.
Last edited by TeamRX8; 04-11-2006 at 12:03 AM.
04-11-2006, 12:40 AM
#84
i was almost pissed. if i had pulled that stuff off and your photos would have had a screen it them i would have hexed the nw more RAIN.
anyway. here is a photo of the screen where it sits. need a bigger photo you know my gmail.
beers
anyway. here is a photo of the screen where it sits. need a bigger photo you know my gmail.
beers
Originally Posted by dannobre
OK...the screen fits in the rubber flush with the blue aluminum tube inside the filter.
It is held in place by the MAF holder tube which is screen dia on one end...and Bellows dia on the other....
It is held in place by the MAF holder tube which is screen dia on one end...and Bellows dia on the other....
Thread
Thread Starter
Forum
Replies
Last Post