09 fuel pump
#1
Rotary engine addict
Thread Starter
Join Date: Jun 2008
Location: Guadeloupe (FWI)
Posts: 303
Likes: 0
Received 0 Likes
on
0 Posts
09 fuel pump
Hi all,
I am desperatly looking for a website where I canbuy the 09 fuel pump.
As my fuel filter is more then dirty...the quickest way is to change the pump and I really want to upgrade mine to the 09' model
thanks
I am desperatly looking for a website where I canbuy the 09 fuel pump.
As my fuel filter is more then dirty...the quickest way is to change the pump and I really want to upgrade mine to the 09' model
thanks
#2
Registered
Join Date: Jun 2006
Location: Dublin, Ireland
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
Check this thread for the part number (N3R1-13-35Z)
https://www.rx8club.com/series-ii-technical-trouble-shooting-160/mechanical-changes-rx-8-series-i-ii-161665/page6/
and maybe purchase from here-
http://www.trademotion.com/partlocat...?siteid=214264
https://www.rx8club.com/series-ii-technical-trouble-shooting-160/mechanical-changes-rx-8-series-i-ii-161665/page6/
and maybe purchase from here-
http://www.trademotion.com/partlocat...?siteid=214264
#8
#10
#12
I did the 09 pump install with OD's many help. Here's my additional help:
I used a nylon/plastic trim removal tool (Harbor Freight) and a heavy-weighted hammer (Home Depot-return afterwards) to pound the retaining nut out.
Move the driver's seat forward (electric) before you cut the power to the car. I was too lazy to reconnect the battery and good thing I'm small.
The submersible tubing must be SAE 30 R10 grade (important). They're not cheap. You buy it by the foot, but only need to use about 3-4in or so. You'll also need two clamps (worm geared type).
The electrical connector that needs to be moded is the one inside the fuel tank that connects to the fuel pump. Remove it and replace it with the one from the old pump. Trim off the locking tab per OD. Note the colors/slot of the wire's location.
I used a nylon/plastic trim removal tool (Harbor Freight) and a heavy-weighted hammer (Home Depot-return afterwards) to pound the retaining nut out.
Move the driver's seat forward (electric) before you cut the power to the car. I was too lazy to reconnect the battery and good thing I'm small.
The submersible tubing must be SAE 30 R10 grade (important). They're not cheap. You buy it by the foot, but only need to use about 3-4in or so. You'll also need two clamps (worm geared type).
The electrical connector that needs to be moded is the one inside the fuel tank that connects to the fuel pump. Remove it and replace it with the one from the old pump. Trim off the locking tab per OD. Note the colors/slot of the wire's location.
#13
Rotary engine addict
Thread Starter
Join Date: Jun 2008
Location: Guadeloupe (FWI)
Posts: 303
Likes: 0
Received 0 Likes
on
0 Posts
thanks to OD for his testing and ideas...
I'll give it a try very soon...
a DIY with picts should have be great to complete this concept
I'll give it a try very soon...
a DIY with picts should have be great to complete this concept
Thread
Thread Starter
Forum
Replies
Last Post