dmp

yeah..bfd...another rx8 w/ clear corners.. :D

I got them, WITH bulbs, from japanparts on ebay for $57 SHIPPED...took 8 days.

One can see they are larger than the OEM corner lights...and w/ the amber bulb there will be no Washington State (Revenue Collection) Patrol bitchin at me.

9G Redline

How hard were they to install? Did you have to remove the front bumper cover etc.?

Thanks,

9G

ZoomZoomH

iTrader: (1)

go to the DIY section and look up 'clear corner install'

20 minute job IIRC.

dannobre

iTrader: (3)

Good to see you steppin up to the plate :D

dmp

Less than 20 minutes...I used the DIY thread...removed 3 of the inner-fender 'screw' things...then the one screw holding the lamp in. The bulb is connected to a plug which is attached to the bumper - remove that plug at the attachment point, and it's much easier to disconnect the two pieces.

dmp

Next will be the clearer-colour driving/fog lamps :D


Then Canzoomer...

Then Muffler

then RB intake (if it shows to be worth anything)...

then...coil-overs...

:D

hehe

HottRx8Girl

I just got mine last week from the same person, and they came in 4 days. Did you remove the reflector piece like in the DIY? I had trouble with it and then gave up

dmp

I left the reflector plate in.

Nemesis8

iTrader: (3)

dmpricerdude8 is now your new official Delta Kai name

Moostafa29

Now all you need is a giant wing...I think clear corners was my first mod too. Car just doesn't look right without them in my opinion.

Labop

I left my reflector plate in as well. Really simple mod and a great DIY.

I don't think this mod couunts as rice, it complements the car.

JOHNRX8

TOTAL RICE !!! J/K looks good1

Straight8

How many tanks of gas you think will be in between the above?? :p

dmp

No fewer than 100, I'd guess.

dazygirl415

Removing the reflector really isn't that difficult. Just hang on tight w/pliers and pull really hard.

Chino075

To remove the reflector, just use a screwdriver (minus) and poke it, and it will pop out. Then you will just have to "navigate" the reflector to the exit.

Al

shinka213

Clears look great......I took the reflector out of mine.....its not that difficult especially if you follow the DYI.....it also gives it a better look when its lit.....
I just finished putting on strakes......they give the clears even a nicer look

RX4life

now all you need are some 15 inch honda rims with peeling chrome.. a gigantic wing that doesnt match the colour of the car ...lots of fake carbon fibre stickers...lots of stickers of the brands of all the mods you DONT have...purple tint... aND FINALLY the creme de la creme.... APC FART CAN!!!!!!!! oh yea!

good luck on your rice quest..

BigOLundh

iTrader: (1)

0r push really hard to slide it out of its holding, then gently pull it out