I'm officially a ricer now...first 'looks mod' - clear corners.
3 Attachment(s)
yeah..bfd...another rx8 w/ clear corners.. :D
I got them, WITH bulbs, from japanparts on ebay for $57 SHIPPED...took 8 days. One can see they are larger than the OEM corner lights...and w/ the amber bulb there will be no Washington State (Revenue Collection) Patrol bitchin at me. :) |
How hard were they to install? Did you have to remove the front bumper cover etc.?
Thanks, 9G |
go to the DIY section and look up 'clear corner install'
20 minute job IIRC. |
Good to see you steppin up to the plate :D
|
:)
Less than 20 minutes...I used the DIY thread...removed 3 of the inner-fender 'screw' things...then the one screw holding the lamp in. The bulb is connected to a plug which is attached to the bumper - remove that plug at the attachment point, and it's much easier to disconnect the two pieces. :) |
Originally Posted by dannobre
Good to see you steppin up to the plate :D
Next will be the clearer-colour driving/fog lamps :D Then Canzoomer... Then Muffler then RB intake (if it shows to be worth anything)... then...coil-overs... :D hehe |
Originally Posted by dmp
yeah..bfd...another rx8 w/ clear corners.. :D
I got them, WITH bulbs, from japanparts on ebay for $57 SHIPPED...took 8 days. One can see they are larger than the OEM corner lights...and w/ the amber bulb there will be no Washington State (Revenue Collection) Patrol bitchin at me. :) |
Originally Posted by HottRx8Girl
I just got mine last week from the same person, and they came in 4 days. Did you remove the reflector piece like in the DIY? I had trouble with it and then gave up :confused:
I left the reflector plate in. |
dmpricerdude8 is now your new official Delta Kai name :)
|
Now all you need is a giant wing...I think clear corners was my first mod too. Car just doesn't look right without them in my opinion.
|
I left my reflector plate in as well. Really simple mod and a great DIY.
I don't think this mod couunts as rice, it complements the car. |
TOTAL RICE !!! J/K looks good1
|
Originally Posted by dmp
Next will be the clearer-colour driving/fog lamps :D
Then Canzoomer... Then Muffler then RB intake (if it shows to be worth anything)... then...coil-overs... :D hehe |
Originally Posted by Straight8
How many tanks of gas you think will be in between the above?? :p
No fewer than 100, I'd guess. :( |
Removing the reflector really isn't that difficult. Just hang on tight w/pliers and pull really hard.
|
To remove the reflector, just use a screwdriver (minus) and poke it, and it will pop out. Then you will just have to "navigate" the reflector to the exit.
Al |
Clears look great......I took the reflector out of mine.....its not that difficult especially if you follow the DYI.....it also gives it a better look when its lit.....
I just finished putting on strakes......they give the clears even a nicer look |
now all you need are some 15 inch honda rims with peeling chrome.. a gigantic wing that doesnt match the colour of the car ...lots of fake carbon fibre stickers...lots of stickers of the brands of all the mods you DONT have...purple tint... aND FINALLY the creme de la creme.... APC FART CAN!!!!!!!! oh yea!
good luck on your rice quest.. ;) |
Originally Posted by dazygirl415
Removing the reflector really isn't that difficult. Just hang on tight w/pliers and pull really hard.
:) |
All times are GMT -5. The time now is 02:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands