Warming up the 8
#27
Registered
But warming the engine up by driving it immediately increases wear on the engine, since the oil isn't quite up to temp.
In all reality, to get the best performance, with least wear, you do need everything all warmed up, but you don't need to floor it out of the drive way as soon as it's engine's warmed up. Heck, the rear end wouldn't be warmed up either.
In all reality, to get the best performance, with least wear, you do need everything all warmed up, but you don't need to floor it out of the drive way as soon as it's engine's warmed up. Heck, the rear end wouldn't be warmed up either.
Multi viscosity oils address the problem of cold oil being thick. If you run a single weight oil, then warming by idling makes sense. Warming single-grade oil before starting the engine makes even more sense.
Ken
#29
SARX Legend
iTrader: (46)
Even when the factory coolant temps says things are warm your oil is not even close to operating temp. I never go anywhere until my oil is at least 130F and usually I play a game of COD while my car warms up so it's typically fully warm by the time I walk out.
Remember the additives are not even working until the oil reaches a certain temp. Driving a car cold is abuse as far as I am concerned but if you must keep RPM around 3,000.
Remember the additives are not even working until the oil reaches a certain temp. Driving a car cold is abuse as far as I am concerned but if you must keep RPM around 3,000.
#32
I think that CoD is a good solution. That way you are distracted from all the fuel dilution that you're causing.
I think cold starts are just a curse either way. The good news is that the seals will always go first, so it doesn't really matter.
I think cold starts are just a curse either way. The good news is that the seals will always go first, so it doesn't really matter.
#33
SARX Legend
iTrader: (46)
No fuel dilution here, I drive my car hard when warmed up. Plus according to my oil test results the Mobil1 is near perfect after 3,000 miles.
Last edited by 9krpmrx8; 04-11-2011 at 04:21 PM.
#35
Strength/Confidence
+1 having to wait for my car warm up has resulted in a few lateness to work LOL.
If its not too cold... turn on, drive slowly, rpms below 4k, untill she warms up.
If its abasolutely cold.. turn on, wait till needle moves a bit, then start drive but still keep under 4k, until she warms up.
Its better to warm up the engine under load (in other words, driving it then letting it sit there to fully warm up).
Have a nice day
If its not too cold... turn on, drive slowly, rpms below 4k, untill she warms up.
If its abasolutely cold.. turn on, wait till needle moves a bit, then start drive but still keep under 4k, until she warms up.
Its better to warm up the engine under load (in other words, driving it then letting it sit there to fully warm up).
Have a nice day
#37
Registered
Join Date: Jan 2004
Location: Milwaukee Wi.
Posts: 997
Likes: 0
Received 0 Likes
on
0 Posts
Cars suck alot of gas when driven cold because they are in full choke mode. Rx8s are no exception. So I try to warm it up a few minutes before I drive it. Warm up at idle saves gas. I hope.
#38
Flame On!
iTrader: (4)
I wait till the air pump is done then drive off, keep the rpms below 4k till she is warmed up to the dead zone, about 10mins after that I drive how I feel.
If its really cold outside I might let it idle for 2 mins before driving off.
Thread
Thread Starter
Forum
Replies
Last Post