Notices
RX-8 Discussion General discussion about the RX-8 that doesn't fit in one of the specialty forums.
Sponsored by:
Sponsored by: CARiD

Coming out of Storage

Thread Tools
 
Rate Thread
 
Old Jul 22, 2018 | 09:31 AM
  #1  
TheWyvern's Avatar
Thread Starter
Enjuhnear
 
Joined: Nov 2016
Posts: 125
Likes: 17
From: Cleveland
Coming out of Storage

Hello gents,



It's been a while.



I've been away from the 8 across the country for around 9 months now. I've had my 8 in storage for 7 of those months. Before storing, I placed some stabilzer in the gas tank, pulled the battery, placed the car in neutral and chucked the wheels with the handbrake disengaged. One regret I have is that the car was not placed on stands in the garage as my real estate is much too small. I have the vehicle covered in a microfiber insulate cover.



My question to you fine folks is what the general protocol is for taking these bad boys out of storage. I've been recommended the following:



-remove the spark plugs
-place Idemitsu/2 stroke oil in the housings
-hand crank the motor over a few times
-repeat step 2 and hand crank again
-clean spark plugs
-reconnect the battery and start the vehicle
-get tires rebalanced and rotated


Should I be concerned running the stabilized gasoline with a two stroke mix? I'm not sure if these compounds have known to "play nice".



Any suggestions/experiences with taking an 8 out of storage would be appreciated guys. Only two weeks until I'm reunited with her!



-Wyvern

Last edited by TheWyvern; Jul 22, 2018 at 01:01 PM.
Reply
Old Jul 22, 2018 | 02:53 PM
  #2  
Loki's Avatar
Registered
iTrader: (1)
 
Joined: Jun 2009
Posts: 8,379
Likes: 1,105
From: Montreal
Inspect visually for rodent damage and flat tires. Connect battery, start car, let it warm up to temp, go for a gentle drive I don't really understand the remove spark plugs/clean spark plug business.

No concerns about 2 stroke and stabilizer.

Source: store my car every winter.
Reply
Old Jul 22, 2018 | 05:21 PM
  #3  
mazdaverx7's Avatar
RX-Heaven
iTrader: (6)
 
Joined: Sep 2008
Posts: 2,287
Likes: 256
From: Vermilion Ohio
I agree with the above. nothing special needed really. Air pressure and rodent damage would be my biggest concern really. You've really covered most of the bases as far as storing your car. I don't see a need to remove the plugs to install oil into the housings. Should not be an issue as far as oil starvation is concerned. May want to replace the engine oil and filter though as its sat for 7 months. I replace the oil in all of my cars once per year at minimum, even if I don't drive them the 3000 mile interval that I like to change the oil at.
Reply
Old Sep 11, 2018 | 07:55 AM
  #4  
Suich's Avatar
Professional Rotard
 
Joined: Jul 2018
Posts: 23
Likes: 2
From: Youngstown, Ohio
Just make sure no parts were stolen! Happened to me before!
Reply
Old Sep 11, 2018 | 05:04 PM
  #5  
Zerg_Rush's Avatar
Registered
 
Joined: Sep 2014
Posts: 20
Likes: 1
From: Sacramento, CA
Originally Posted by Suich
Just make sure no parts were stolen! Happened to me before!
Ouch. Which parts were stolen from your 8?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jsudz08
Series I Tech Garage
4
Mar 17, 2012 02:59 AM
cnc
Series I Tech Garage
5
Jun 30, 2011 07:52 PM
robel82
RX-8 Discussion
11
Nov 17, 2008 10:44 PM
caveney_not_in_use_delete_please
Series I Tech Garage
11
Aug 16, 2007 09:20 PM
newport8
RX-8 Discussion
18
Aug 11, 2005 02:38 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 03:49 PM.