NA SemiPP 20b
#103
Hahah yea... it's been brutal getting things i need to get the engine together. Rotating assembly was at a machine shop adjusting the balance for like 2~3 years. It took them over a year from the time the work was done to just put it in a crate and ship it back, and we were harassing them weekly. It's been an adventure for sure. I'd like to have it running for DGRR, but that will be difficult. Not impossible, but difficult.I dont know if I can get a fabricator in time. That's more my concern. I'll keep posting things as i have info etc. Should move a lot faster soon.
The following users liked this post:
TomD_Cincy (02-15-2024)
#106
Just got a Bosch 82mm DBW throttle body with 20b adapter and 90mm inlet from Pac Performance.
Coils and custom resonator coming from BHR.
Rear diff hard mount from LS1RX8.
Haltech R3 and 3 wide bands. Shawn wants to run these instead of a wide band and 3 EGT sensors. Whatever makes it simpler... it's just NA.
I'm stressing getting this wiring done in time, and hoping that the engine is ready at the expected time... guess we'll see.... I'll try to keep everyone posted.
Coils and custom resonator coming from BHR.
Rear diff hard mount from LS1RX8.
Haltech R3 and 3 wide bands. Shawn wants to run these instead of a wide band and 3 EGT sensors. Whatever makes it simpler... it's just NA.
I'm stressing getting this wiring done in time, and hoping that the engine is ready at the expected time... guess we'll see.... I'll try to keep everyone posted.
The following users liked this post:
RotaryMachineRx (02-23-2024)
#109
No respecter of malarkey
iTrader: (25)
just make your own up to 4” size and to the length/position you want
https://www.spiralturbobaffles.com
who was doing that engine work to take that long?
.
https://www.spiralturbobaffles.com
who was doing that engine work to take that long?
.
#110
It's been several issues, and multiple shops. Chip balance was off, and it took 2 years to get the rotating assembly back from the person that fixed it. That was frustrating. Lots of little things like that where each person has taken way longer than it should have. At least it's finally getting done.
The following 3 users liked this post by reddozen:
Thread
Thread Starter
Forum
Replies
Last Post
cretinx
Series I Exterior Appearance and Body Kits
14
08-13-2007 05:41 PM