Hello All,
Whilst trying in vane to swap out my SAS module behind the Radio, I discovered some wires without connectors.

I have remove the ashtray, centre console etc. and disconnected cigar lighter, bulb etc.
There are 2 wires, sheathed, which went back into the dash, connected to the cigar lighter connector.
The 12v has an inline fuse, (same style fuses as main fuse box)

seems to be supply to something

Hadn't noticed it until I pulled the cable to one side and the wire came out.
They have bare ends, like I may have snagged them at some point against a sharp edge and cut them.
not that I remember being the rough.

Although I did get frustrated about not being able to get to the SAS module connectors.

Can anyone tell me where they go ?

Help !!! :-(

Shaun

 

An inline fuse holder will be aftermarket.... so someone had something connected to the 12v power from the lighter circuit. Likely whatever it was is long gone so just disconnect it. Likely the fuse is not there or you would have shorted it out long ago