New member from Alberta checking in
Thread Starter
Registered
Joined: Apr 2016
Posts: 66
Likes: 0
From: Edmonton Alberta Canada
New member from Alberta checking in
Hello everyone. Recently bought a 2006 MT and have been lurking on the forum for a few weeks. Lots of excellent info which I've already put to use. Had a bit of a backfire, hot start issue and just resolved thanks to the info on the forum. Just replaced coils, plugs, wires and no more issues!
3 of the spark plug wires were improperly seated and the coil on the far right was shot. The car runs nice and smooth now and fires up immediately when hot.
3 of the spark plug wires were improperly seated and the coil on the far right was shot. The car runs nice and smooth now and fires up immediately when hot.
///// Upscale Zoom-Zoom
Joined: Nov 2009
Posts: 1,593
Likes: 190
From: Massachusetts
Hello everyone. Recently bought a 2006 MT and have been lurking on the forum for a few weeks. Lots of excellent info which I've already put to use. Had a bit of a backfire, hot start issue and just resolved thanks to the info on the forum. Just replaced coils, plugs, wires and no more issues! 3 of the spark plug wires were improperly seated and the coil on the far right was shot. The car runs nice and smooth now and fires up immediately when hot.
3 of the spark plug wires were improperly seated and the coil on the far right was shot. The car runs nice and smooth now and fires up immediately when hot.
Thread Starter
Registered
Joined: Apr 2016
Posts: 66
Likes: 0
From: Edmonton Alberta Canada
Yes, I had read that already but I used an ohm meter to verify the coils and found the one I indicated as dead had open terminals. Zero ohms across across terminals.
Thread
Thread Starter
Forum
Replies
Last Post
