Damn, how could I miss that?

 

I have super secret ebay searching powers that I cannot reveal....

 

I'll "buy it now" for $20.00.

 

Good game guys! I loved the outcome... of course.

 

my motor is pissing me off...
only thing standing between me and a finished motor is 1 rear stationery gear screw

 

The outcome was absolute bullshit!!!!!


You need one or it was damaged?

 

..................lol

 

i need one...i believe its a special lockscrew
gotta order it from mazda

 

Well, was tired of waiting so I got my second clip with the new exhaust. The parking lot I used was a little shorter than the first one I used so I had to brake immediately after redline but you can still get the general idea.

http://www.youtube.com/watch?v=LB2HUq1hRaY

[embed]LB2HUq1hRaY[/embed]

 

Damn, it's louder!!! I love it.

 

sounds good... i noticed it the day you left, i could here you getting on it turning on to callaghan

 

Is it really that loud? lol. I dont think I even hit redline at that time since I had the old exhaust resting in my rear seats.

 

yup.... it was noticable

 

My damn exhaust is taking too long to get here! >:[

 

A watched pot never boils.

 

Are "We" going to install this at Jay's?
I am really curius how it sounds...
for $499 with resonated midpipe that is a deal...

 

Juan make sure you have all the gaskets,. etc. when you get it.

Hey corn, I need to splice a larger 18 gauge wire into the much smaller ground on the cigarette lighter. I tried to use a quick splice but it does not splice into the smaller wire to make a connection. Currently I have it grounded to a bolt but I am getting intermittent error codes on my gauge and they say its due to a bad ground.

 

you might have to cut the wires and go with a butt splice or even a bean splice, i have never seen anything that will allow for splicing of different gauges

 

my garage is always open..... i will helping autotragic install the satty radio in his car this saturday

 

I don't want to have to cut or solder because there is no damn room to work as it is. But I guess I will have too. Can I come Saturday? I wanna install my grounding kit and fix this gauge. My tire guy was out and still has the minivan. I want my freakin' rims already.

 

sure... come on over

if possible check out my dads car to see what is causing the "clicking"

 

Yeah we can check it out. You have a soldering iron and solder?

 

that i do not have.... i use to but dont know what happened to it.... just glad i found my dremel for now lol

 

just split the ground wire from the lighter and use a butt connector to attach the wire for gauge wire as in this pic below

if there is no room get a T Tap and Male Blade connector

 

So two wires in the end of one butt connector? The wire from the oil temp gauge is 18 gauge.