Steering torque sensor cap
Thread Starter
Registered
Joined: Aug 2013
Posts: 94
Likes: 2
Steering torque sensor cap
Hi guys,
Does anyone know if the top part clips or screws down onto the bottom part, or does it just stay there loosely?
Thanks
Top part sitting on the torque position sensor
Does anyone know if the top part clips or screws down onto the bottom part, or does it just stay there loosely?
Thanks
Top part sitting on the torque position sensor
The Blue Blur
iTrader: (3)
Joined: Apr 2010
Posts: 1,974
Likes: 4,820
From: Green Hill Zone Running in Loops
The bottom part has 3 screws that attach it to the steering rack, the top part is smushed in place by the steering column
edit: here's a pdf with important specs and what not
http://www.rotaryheads.com/PDF/RX8/8Steering.PDF
edit: here's a pdf with important specs and what not
http://www.rotaryheads.com/PDF/RX8/8Steering.PDF
Last edited by sonicsdaman; Nov 21, 2018 at 09:08 AM.
Thread Starter
Registered
Joined: Aug 2013
Posts: 94
Likes: 2
Thanks for all the info. It is just forced in place by the steering column then. No real super tight seal etc. I can lift the boot up but not past the steering column so all the above makes sense now.
Thread
Thread Starter
Forum
Replies
Last Post
Nopstnz8
Series I Trouble Shooting
8
Dec 10, 2012 11:26 PM