{ FS } Tokico Adjuster Cables and Tanabe GF210 Lowering Springs
06-24-2011, 04:48 PM
#1
Registered
Thread Starter
iTrader: (7)
Join Date: Aug 2009
Location: San Antonio, TX
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
Tokico Adjuster Cables and Tanabe GF210 Lowering Springs
Category: Steering & Suspension
Price: $0
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): Series I
Location (US State/Canada/Int): TX
Item Condition: Used
I have up for sale is a pair of Tokico adjuster cables that are used to adjust rear Tokico D-spec shocks. Asking $30 OBO shipped to the lower 48.
I also have a set of Tanabe GF210 lowering springs that have ~20k on them.
Asking $150 OBO shipped to the lower 48.
I'll keep this posted for about a month or so before heading over to ebay. Let me know if you want them!
Thanks for looking!
Last edited by silverbullet05; 07-18-2011 at 11:22 AM. Reason: Pictures added!
07-19-2011, 02:49 PM
#5
Registered
Thread Starter
iTrader: (7)
Join Date: Aug 2009
Location: San Antonio, TX
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
9k: I'll consider trades as well.
I have been offered higher than 100 shipped on the springs, so holding it until Friday "Pending" any other offers.
I have been offered higher than 100 shipped on the springs, so holding it until Friday "Pending" any other offers.
07-19-2011, 03:46 PM
#7
Registered
Thread Starter
iTrader: (7)
Join Date: Aug 2009
Location: San Antonio, TX
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
Yikes, what happened to your motor??? so now you're on number 4 lol
nothing in particular... what do you have?
i just put stock springs & shocks on after my rear dspec's blew out. considering sway bars to get some of the body roll under control. I miss the performance of the springs....
nothing in particular... what do you have?
i just put stock springs & shocks on after my rear dspec's blew out. considering sway bars to get some of the body roll under control. I miss the performance of the springs....
07-19-2011, 04:00 PM
#8
SARX Legend
iTrader: (46)
Yeah ******* shitty Mazda remans. This was a coolant seal failure. It still starts and drives fine once it warms up but I don't want to ruin the housings so I parked it and will be yanking the motor out soon.
I dunno, I have stuff you probably don't need
maybe I'll sell the megans and buy yours I have a full clutch pedal assembly in case you are worried about yours breaking
Or, trade for almost new S Techs? I'm looking to go lower in the rear.
I dunno, I have stuff you probably don't need
maybe I'll sell the megans and buy yours I have a full clutch pedal assembly in case you are worried about yours breaking Or, trade for almost new S Techs? I'm looking to go lower in the rear.
Last edited by 9krpmrx8; 07-19-2011 at 09:09 PM.
07-28-2011, 10:40 AM
#9
Registered
Thread Starter
iTrader: (7)
Join Date: Aug 2009
Location: San Antonio, TX
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
Bump! still available.
9k: Thanks, but I already have the raceroots clutch bracket installed.
I am fine with the stock height since I had too many issues with the rears going bad and scraping speed bumps lol
If i did lower again, it would be via coilovers.
9k: Thanks, but I already have the raceroots clutch bracket installed.
I am fine with the stock height since I had too many issues with the rears going bad and scraping speed bumps lol
If i did lower again, it would be via coilovers.
Thread
Thread Starter
Forum
Replies
Last Post
duworm
Series I Wheels, Tires, Brakes & Suspension
1
10-01-2015 04:57 PM
jasonrxeight
RX-8's For Sale/Wanted
2
09-30-2015 01:53 PM