{ FS } Greddy Turbo Kit with Xtra
#1
Registered
Thread Starter
iTrader: (2)
Join Date: Feb 2007
Location: Wiscansin
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Greddy Turbo Kit with Xtra
Category: Engine - Power Adders
Price: $2000
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): Series I
Location (US State/Canada/Int): WI
Item Condition: Used
I had a custom upper intake manifold fabricated to replace the stock plastic one. The stock mani may not handle the pressure when boosting, as Mazda designed it to run under vacuum not boost. My custom manifold is made using the same upper intake manifold that comes with the Pettit Racing Supercharger kit..slightly modified of course.
Between 5-6k miles on the turbo kit
PRICE DROP $2000 OBO + shipping
PICTURES BELOW SCROLL DOWN
Last edited by ARC.4.LYFE; 10-15-2012 at 07:35 PM.
#7
Registered
Thread Starter
iTrader: (2)
Join Date: Feb 2007
Location: Wiscansin
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
The down pipe has additional bungs, the original O2 sensor bung and another for an air/fuel ratio gauge. The smaller bung is for an exhaust temp gauge or can be capped off if you dont want to use it.
Last edited by ARC.4.LYFE; 09-30-2012 at 12:55 PM. Reason: added info about picture
#8
weeeeeeeeee
iTrader: (12)
now that's worthy of a mention ... nice addition to the exhaust. up close nice and neat right where it should be.
I'd consider the GReddy exhaust pieces if you decide to part out. I've been wanting to have a stand-by ceramic coated exhaust manifold for a while.
I'd consider the GReddy exhaust pieces if you decide to part out. I've been wanting to have a stand-by ceramic coated exhaust manifold for a while.
#20
Registered
Thread Starter
iTrader: (2)
Join Date: Feb 2007
Location: Wiscansin
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
When I installed the turbo kit I had a thought that the stock upper intake would perform better and look better if it were made of aluminum. Like I said before the stock mani really was designed for vacuum conditions not being pressurized. I got the intake mani from Pettit Racing to use as platform to build my custom turbo intake.
Thread
Thread Starter
Forum
Replies
Last Post
TotalAutoPerformance
Vendor Classifieds
12
10-17-2018 09:00 AM