installing racing beat intake
#1
Guest
Posts: n/a
installing racing beat intake
planning on getting the racing beat intake and ram air duct for 09. I've never done much modding to a car and wonder how hard is it to take the nose off the car. Not interested in performance aspect responses just want advice on istalling this particular intake thanks.
#4
no agenda
iTrader: (2)
I don't understand why you couldn't tell ..... the website has instructions on how to remove the bumper.
If you are unable to asses the difficulty in doing this job on your own, by reading the instructions then maybe this is a task to challenging for you.
http://www.racingbeat.com/RX8/Intake...ers/18297.html
If you are unable to asses the difficulty in doing this job on your own, by reading the instructions then maybe this is a task to challenging for you.
http://www.racingbeat.com/RX8/Intake...ers/18297.html
#6
no agenda
iTrader: (2)
We have the same law here in Ontario.
Yes unfortunately it will block some of the Ram Air intake .... if I was to guess .... ummmmm
An Ontario plate likely covers at least 50%+ of the available intake area.
You don't "have to" relocate the plate, I haven't bother relocating my plate ...
Or you could take a chance and drive without a front plate?
Yes unfortunately it will block some of the Ram Air intake .... if I was to guess .... ummmmm
An Ontario plate likely covers at least 50%+ of the available intake area.
You don't "have to" relocate the plate, I haven't bother relocating my plate ...
Or you could take a chance and drive without a front plate?
#7
Registered
The law here is if your car maker sells a front plate mount then you must use a front plate. I have been driving around with no front plate since I bought the car almost a year ago and never had any issues at all.
I'm sure its a fixit ticket anyway in the unlikely event you did get pulled over.
I'm sure its a fixit ticket anyway in the unlikely event you did get pulled over.
#8
Surf Hard, Drive Hard
Join Date: Feb 2007
Location: Indialantic, Florida
Posts: 7,840
Likes: 0
Received 11 Likes
on
9 Posts
I don't understand why you couldn't tell ..... the website has instructions on how to remove the bumper.
If you are unable to asses the difficulty in doing this job on your own, by reading the instructions then maybe this is a task to challenging for you.
http://www.racingbeat.com/RX8/Intake...ers/18297.html
If you are unable to asses the difficulty in doing this job on your own, by reading the instructions then maybe this is a task to challenging for you.
http://www.racingbeat.com/RX8/Intake...ers/18297.html
Thread
Thread Starter
Forum
Replies
Last Post