variation of metra problem
#1
Registered
Thread Starter
iTrader: (1)
Join Date: May 2011
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
variation of metra problem
Before I go on, I've tried searching and read through quite a bit of the metra thread...
I bought a new metra kit from crutchfield and installed a jvc avx840. After much pain and trouble, I've managed to install everything and get it up and running.
When I plugged in my climate controls, nothing worked except the fan. The A/C was permanently on (displaed on dash display + light on the button), but everything was unresponsive. I took everything out and tried the 3 solder point fix and BOOM, i had control again!
Except... No LEDs on the climate control. Interestingly enough, the illumination works fine; its just the lights on the buttons. I know they are all working because they all function and the display reflects this as well. It's just I can't tell when I've pressed them because the lights on the buttons aren't working. Any ideas? I've double/triple checked my wiring, and everythings good.
I bought a new metra kit from crutchfield and installed a jvc avx840. After much pain and trouble, I've managed to install everything and get it up and running.
When I plugged in my climate controls, nothing worked except the fan. The A/C was permanently on (displaed on dash display + light on the button), but everything was unresponsive. I took everything out and tried the 3 solder point fix and BOOM, i had control again!
Except... No LEDs on the climate control. Interestingly enough, the illumination works fine; its just the lights on the buttons. I know they are all working because they all function and the display reflects this as well. It's just I can't tell when I've pressed them because the lights on the buttons aren't working. Any ideas? I've double/triple checked my wiring, and everythings good.
#2
The Black Pearl
iTrader: (2)
Join Date: Jan 2009
Location: Houston, Texas
Posts: 212
Likes: 0
Received 0 Likes
on
0 Posts
try switching your leads. I had that happen when i plugged the leads in backwards. Make sure the extensions are pluging into the right place. unplug them and switch them around
Thread
Thread Starter
Forum
Replies
Last Post
jasonrxeight
RX-8's For Sale/Wanted
2
09-30-2015 01:53 PM
tommy26Germany
Series I Trouble Shooting
11
09-29-2015 10:33 AM
Learners_Permit
Series I Interior, Audio, and Electronics
8
09-27-2015 07:38 PM