PLEASE help me, my BABY wont Start with video!!!
#1
Registered
Thread Starter
iTrader: (1)
Join Date: May 2009
Location: utica- new york
Posts: 301
Likes: 0
Received 0 Likes
on
0 Posts
PLEASE help me, my BABY wont Start with video!!!
hi rx8 brother,, i was busy with school and and it was cold out and i haven't start my car for 3 week, today ,i try to start it , but it wont start, i try to jump it but it still wont start and it make this sound and here is the video
+new baterie
+new ignition coil
+36000 mile
+2005
+got new NGK spark plug and wires for 110 from advanautozone but dint put it in yet
http://www.youtube.com/watch?v=Qg0t9puPfus
+new baterie
+new ignition coil
+36000 mile
+2005
+got new NGK spark plug and wires for 110 from advanautozone but dint put it in yet
http://www.youtube.com/watch?v=Qg0t9puPfus
#4
Take out the starter and test it on the bench to see if it kicks out (hook it up to a 12v battery and terminals on starter ) . Just so happens the starters on the 8's are by far the easiest ones to remove ive ever delt with (under the car beside tranny) You can have it rebuilt or by a new upgraded one while your at it and have the extra funds .
#7
bckrdsonlyplz
Join Date: Jul 2010
Location: hampton roads/washington dc
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
the diy is very simple. jack up the car go in from the drivers side locate the starter next to the tranny and undo the two cables on it. one is a 10 or 12mm and the other is just a clip which is the ground wire. then undo the two bolts holding it in. possibly 14mm i believe. once theyre out it should fall right out. put in new starter and reatatch in opp order.
#11
U.S Army
iTrader: (6)
Join Date: Jun 2010
Location: Ohio
Posts: 210
Likes: 0
Received 0 Likes
on
0 Posts
^+1 did the same thing with autozone, you could also tap the starter with a hammer and have another try to start the car. Thats how i tested my starter and when or if u push start it ur traction control light might stay on but it will go off by the next time u drive it.
#12
Registered
Thread Starter
iTrader: (1)
Join Date: May 2009
Location: utica- new york
Posts: 301
Likes: 0
Received 0 Likes
on
0 Posts
aahha sound GOOOD haha i was reading other post they say it cost like 321 i like dam that alot ahah , do u guy know if i bring to the dealer do my warranty cover this?i still have warranty to 2012
#15
FULLY SEMI AUTOMATIC
iTrader: (9)
ya cant tow start an auto
#19
FULLY SEMI AUTOMATIC
iTrader: (9)
get a hammer
hit starter with hammer
try to start
if starter does not engage repete
hit starter with hammer
try to start
if starter does not engage repete
#20
Boosted Kiwi
iTrader: (2)
The engine is not turning over - it's just the starter spining because the pinion gear has not moved forward to engage the flywheel .
So - flooding has nothing to do with it .
Sometimes tapping the body of the starter motor may help to get the pinion to move forward - SOMETIMES .
So - flooding has nothing to do with it .
Sometimes tapping the body of the starter motor may help to get the pinion to move forward - SOMETIMES .
Thread
Thread Starter
Forum
Replies
Last Post
rx8wankelrotary
New Member Forum
9
08-17-2015 10:42 AM