Exhaust seal/silencer replacement?
#1
Exhaust seal/silencer replacement?
I installed an aftermarket cat about a month ago and reused the crush gasket, I ordered a replacement gasket and plan on installing it this weekend. I saw on Mazmart that there is a seal/silencer on the back end of the cat so I ordered one too not seeing one when I replaced the cat. The seal is not obvious to me how it would be installed or even work. The seal is item number 8 on this picture:
Here is a pic of the seal on ebay
I cannot find any info on the forum or internet about this seal. Is it just as simple as placing it in between the car and the straight pipe? What orientation to I put it in? Do I use a gasket sealer?
The new cat is an bolt on replacement Magnaflow 49150
Thanks for any info.
2004 RX8 6MT, 97K.
Thanks.
Here is a pic of the seal on ebay
I cannot find any info on the forum or internet about this seal. Is it just as simple as placing it in between the car and the straight pipe? What orientation to I put it in? Do I use a gasket sealer?
The new cat is an bolt on replacement Magnaflow 49150
Thanks for any info.
2004 RX8 6MT, 97K.
Thanks.
#3
No respecter of malarkey
iTrader: (25)
try searching "exhaust donut seal"
you will get plenty of info, including the infamous "exhaust & **** comes out here" thread
https://www.rx8club.com/tech-garage-...t-leak-156459/
you will get plenty of info, including the infamous "exhaust & **** comes out here" thread
https://www.rx8club.com/tech-garage-...t-leak-156459/
Thread
Thread Starter
Forum
Replies
Last Post
Kanthinar
New Member Forum
15
12-21-2015 01:24 PM
dbarber
Series I Trouble Shooting
14
07-25-2015 01:34 PM