Notices
Series I Tech Garage The place to discuss anything technical about the RX-8 that doesn't fit into any of the categories below.

Is it true?

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 04-05-2008, 07:09 AM
  #1  
Registered
Thread Starter
 
yenphi's Avatar
 
Join Date: Sep 2007
Posts: 91
Likes: 0
Received 0 Likes on 0 Posts
Is it true?

I change the tranny oil, I thought it is about some where at 2 quarts but my car swallows almost 3 quarts ( about 2.8 quarts to be exact) Am I over fill or it is the right amount, I just keep pumping in until the fill-hole start to leak out, and after a few days, shift is not feeling right, it is harder on 1st and 2nd a little bit, any thought or comment is appreciated, thanks
PS: I changed and put 2 quarts in few months back and it was shift harder at 2nd gear compare with the original when I bought the car as used, last week I pump almost 1 quarts in also to make total of 2.8 quart, I use redline mt90 as recommend here in this forum.
Old 04-05-2008, 07:32 AM
  #2  
Got Another Rotary
 
Jax_RX8's Avatar
 
Join Date: Aug 2006
Location: Fredericksburg, VA
Posts: 608
Likes: 0
Received 2 Likes on 2 Posts
You overfilled it, it should only hold about 1.6 quarts if I am remembering correctly - likely the car was not level when you jacked it up. I suspect you leaned the car sideways, which would allow the trans to take on much more oil.

You will want to jack the car up again - make sure it is level and on 4 stands - and remove the top plug and let the excess oil train out. If you do not, this excess oil WILL cause you trans to run hot! which is not good over the long haul.
Old 04-06-2008, 12:00 PM
  #3  
Registered
Thread Starter
 
yenphi's Avatar
 
Join Date: Sep 2007
Posts: 91
Likes: 0
Received 0 Likes on 0 Posts
thanks, i did jack the car up only one side (driver side). if I level the car, open the fill- bolt, assume if there is no oil coming out, is it still ok? or i have to drain out about a quart? thanks again
Old 04-06-2008, 02:07 PM
  #4  
Got Another Rotary
 
Jax_RX8's Avatar
 
Join Date: Aug 2006
Location: Fredericksburg, VA
Posts: 608
Likes: 0
Received 2 Likes on 2 Posts
Originally Posted by yenphi
thanks, i did jack the car up only one side (driver side). if I level the car, open the fill- bolt, assume if there is no oil coming out, is it still ok? or i have to drain out about a quart? thanks again
If jack up the car and get it perfectly level (side to side and front to back), then take the top (fill) plug out - let it drain. If nothing drains, then you are not overfilled as the top plug is the fill level.

That said, if car was lifted on the drivers side only, I guarantee you have too much fluid in there.

Hope this helps
Old 04-09-2008, 09:46 AM
  #5  
Registered
Thread Starter
 
yenphi's Avatar
 
Join Date: Sep 2007
Posts: 91
Likes: 0
Received 0 Likes on 0 Posts
haha, the car at perfect level, i jack it up, open the fill bolt, low it down and it drains out about 600ml ,thanks for the reply again.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
chadsta
RX-8 Parts For Sale/Wanted
0
09-20-2015 11:00 PM
superROB23
Series I Aftermarket Performance Modifications
4
09-04-2015 01:22 AM
mariohardleft
New Member Forum
14
08-28-2015 09:26 PM
redrx82015
New Member Forum
0
08-28-2015 12:30 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: Is it true?



All times are GMT -5. The time now is 11:16 PM.