Hey everyone

Its been a while since I've driven my 8 as its been sitting waiting for a dispute with some shops to come to a conclusion.

Its finally come to an end and I'm ready to get my 8 back on the road.

One thing the shop did was replace the push rod with a bolt (approx 11cm). I know this is stupid and it was only to hide a problem with their installation but I wont go into that.

My question is, what is the actual length of the RX8s push rod? I need to know this so I can grind down this bolt to the correct length while I am waiting for my replacement push rod.

Thanks

 

The slave cylinder is 80mm, the master cylinder is 75mm.