Need some SARD boost control help.....
#1
Metatron
Thread Starter
iTrader: (1)
Need some SARD boost control help.....
I'm trying to install a SARD 'Trigger' SR-58000 controller, but of course all the documentation is in JDM-ese!
I have the electrical connections and controls mostly figured, but didn't get the hardware diagrams and need a little guidance on the actual plumbing of the hoses; if I understand it, the boost signal goes to the gauge, and the 'OUT' on the pump goes to the wastegate actuator?
I'm confused as to where the pump's 'IN' nipple connects?
- does it get a boost signal too, or just an air inlet for the pump?
.....any SARD plumbers out there?
S
I have the electrical connections and controls mostly figured, but didn't get the hardware diagrams and need a little guidance on the actual plumbing of the hoses; if I understand it, the boost signal goes to the gauge, and the 'OUT' on the pump goes to the wastegate actuator?
I'm confused as to where the pump's 'IN' nipple connects?
- does it get a boost signal too, or just an air inlet for the pump?
.....any SARD plumbers out there?
S
#3
Metatron
Thread Starter
iTrader: (1)
The Sard uses its own pump to open and close the wastegate - independant of the gate's spring pressure or the boost pressure, enabling a change in psi at the touch of a button.
S
S
#5
interesting, stealth. I am using the aem tru boost, while it is decent, it can be confusing. I googled the sard unit, looks really slick. I could not find anything to do with installation though and their website is Japanese...
Thread
Thread Starter
Forum
Replies
Last Post
JimmyBlack
Series I Major Horsepower Upgrades
273
02-10-2020 10:23 PM
yurcivicsux
Series I Major Horsepower Upgrades
192
09-12-2017 10:54 PM
05rx8mazda
RX-8 Parts For Sale/Wanted
18
11-28-2015 09:42 AM
boost, boust, controller, controllers, diagram, install, installation, instruction, nipple, psi, rx7, rx8, sard, threads, trigger, wastegate