Need help sourcing a plug
#1
Fire-Spewing Maniac
Thread Starter
Join Date: Sep 2004
Location: Toronto, Canada
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
Need help sourcing a plug
Ok guys,
I need help sourcing the 5 pin and 7 pin plastic harness plugs that go into the MAF and the throttle body. Anyone know where I can get these?
-Bryan
I need help sourcing the 5 pin and 7 pin plastic harness plugs that go into the MAF and the throttle body. Anyone know where I can get these?
-Bryan
#2
Registered
I doubt if you can purchase just the connectors from Mazda. In which case you would have to do a little detective work to determine the manufacturer and one of their vendors. Then you might have a problem convincing a wholesale vendor to sell you a few connectors. Anyway, try Mazmart (http://www.mazmart.com/) for a used wiring set with the connectors.
#4
Fire-Spewing Maniac
Thread Starter
Join Date: Sep 2004
Location: Toronto, Canada
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
Cool.
We need new plugs, and mazda only sells full harnesses. We need to find the actual maker of the plugs, im thinking its kawaseki, but im not sure.
We need new plugs, and mazda only sells full harnesses. We need to find the actual maker of the plugs, im thinking its kawaseki, but im not sure.
#5
I know that Canzoomer had some difficulty, but was successful, in sourcing the ECU plugs from Tyco. I tried the same thing to help TeamRX8 source some ignition coil connectors, but to no avail. I know that Mitsubishi makes the MAF sensor(which I think is 4-wire) so they may be a place to start asking questions, but I don't yet know who makes the throttle ***'y. That is a 6-wire connector. AMP also makes plugs/connectors for a variety of purposes.
CRH
CRH
Thread
Thread Starter
Forum
Replies
Last Post
JimmyBlack
Series I Major Horsepower Upgrades
273
02-10-2020 10:23 PM
yurcivicsux
Series I Major Horsepower Upgrades
192
09-12-2017 10:54 PM
Rupanrx
Series I Aftermarket Performance Modifications
1
09-04-2015 06:44 AM