Installing rear under deflector(OEM Aero kit)
#1
Hate Scrape 8
Thread Starter
Installing rear under deflector(OEM Aero kit)
The instructions say you have to remove the rear bumper, is there a way in doing this without removing the bumper?
any tips?
any tips?
#2
Registered
Join Date: May 2010
Location: Houston, TX, USA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Yee, remove the little plastic tab (cut it or sand it down) and the clip screw on the rear flares (use a flathead screwdriver to lift the metal clip)
So it ends up being held by the wheel well screw and the 3m tape, which is perfectly fine. You just need to give it some time (1 day or so) so the tape reeeaaally sticks on, as with any tape... (no car wash, no going over water filled pot holes and splashing water all over the road... stuff like that)
So it ends up being held by the wheel well screw and the 3m tape, which is perfectly fine. You just need to give it some time (1 day or so) so the tape reeeaaally sticks on, as with any tape... (no car wash, no going over water filled pot holes and splashing water all over the road... stuff like that)
Last edited by gbsn64; 06-16-2010 at 05:01 PM.
#3
Hate Scrape 8
Thread Starter
Yee, remove the little plastic tab (cut it or sand it down) and the clip screw on the rear flares (use a flathead screwdriver to lift the metal clip)
So it ends up being held by the wheel well screw and the 3m tape, which is perfectly fine. You just need to give it some time (1 day or so) so the tape reeeaaally sticks on, as with any tape... (no car wash, no going over water filled pot holes and splashing water all over the road... stuff like that)
So it ends up being held by the wheel well screw and the 3m tape, which is perfectly fine. You just need to give it some time (1 day or so) so the tape reeeaaally sticks on, as with any tape... (no car wash, no going over water filled pot holes and splashing water all over the road... stuff like that)
#4
Registered
Join Date: May 2010
Location: Houston, TX, USA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
jay_tibo
Series I Aftermarket Performance Modifications
22
09-13-2016 08:10 PM
akagc
RX-8's For Sale/Wanted
7
08-11-2015 07:07 PM
MolecularConcept
New Member Forum
15
08-05-2015 04:43 PM