how do you install clear corners?!?
08-12-2003, 07:18 PM
#3
really easy, just use a Phillip's screwdriver and take off 2 of the plastic screws in the wheel well...just turn then and they pretty much snap off...next pull back the black plastic lining, again, really easy...next look under and you'll see that the clear corner is held up by 1 screw...unscrew it and pull the clear corner out...
i opted to use the original white bulb that came with the car as i don't like the orange that came with the corners so i just twisted the bulb out of the original and the new clear corner and replaced it...
took about 10 minutes total...i had to turn the wheel in the opposite direction of the corner i was changing to allow enough room
i opted to use the original white bulb that came with the car as i don't like the orange that came with the corners so i just twisted the bulb out of the original and the new clear corner and replaced it...
took about 10 minutes total...i had to turn the wheel in the opposite direction of the corner i was changing to allow enough room
08-12-2003, 08:07 PM
#4
Registered User
Thread Starter
Join Date: Apr 2003
Location: irvine/fullerton, ca
Posts: 508
Likes: 0
Received 0 Likes
on
0 Posts
thx i just installed them. was pretty ez. but for some reason the right one was friggin hard to pop out. that little plastic hook/tab wouldnt come out. i damn near broke the tab trying to get that bitch outta there.
08-13-2003, 08:46 PM
#5
Registered
Join Date: Mar 2003
Location: Ottawa,ON
Posts: 1,271
Likes: 0
Received 0 Likes
on
0 Posts
Is this the same method to get to the fender grills? I was looking and was like WTF? It's BLOCKED!
Nice of mazda to put all that plastic there, at least the rocks flying off the tires won't be too loud.
Nice of mazda to put all that plastic there, at least the rocks flying off the tires won't be too loud.
08-15-2003, 11:59 PM
#8
Registered User
Thread Starter
Join Date: Apr 2003
Location: irvine/fullerton, ca
Posts: 508
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by vix8
Could somebody post a pic of these installed? I'd like to see how they look...
Could somebody post a pic of these installed? I'd like to see how they look...
heres mine
http://www.rx8forum.com/showthread.p...5&pagenumber=1
Thread
Thread Starter
Forum
Replies
Last Post
projectr13b
Series I Do It Yourself Forum
1
09-06-2015 01:04 PM