Help on fuel injector
08-31-2009, 01:38 PM
#1
Registered
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: Indy
Posts: 413
Likes: 0
Received 0 Likes
on
0 Posts
Help on fuel injector
Okay guys here is the problem. I just got the engine replaced under warranty but the car runs like crap. They now say it is a clogged fuel injector and injector seal and want $650 to do it. How hard are these to replace? I enjoy working on the car and if I can do this myself, I would prefer to. If it is a pita to pull everything I will just let them, but I hate to pay an bloated dealer cost if it is a simple job. Opinions.... thoughts?
08-31-2009, 04:14 PM
#3
I concur on the injector also....injectors don't plug easily...and don't fail very often
You have to pull the UIM and a few other parts..but not that difficult if you are a bit mechanically inclined....
Did they tell you which injector was plugged? And how did they figure that out
You have to pull the UIM and a few other parts..but not that difficult if you are a bit mechanically inclined....
Did they tell you which injector was plugged? And how did they figure that out
08-31-2009, 06:48 PM
#4
Registered
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: Indy
Posts: 413
Likes: 0
Received 0 Likes
on
0 Posts
Not sure. It was running like crap after engine replacement and they spent 2 days (???) on the phone with mazda engineering trying to diagnosis the problem. I am not a fan of mazda techs but, unlike some of you, my knowledge only goes so far so I am forced to rely on others. This is not a feeling I like.
Thread
Thread Starter
Forum
Replies
Last Post
