Effects of overheating..
#51
Bleeding the system
For a Rotary, the "overheated" crack will most likely start at around the spark plug holes. then it will slowly spread until of course, coolant runs into the engine.
is pretty easy to bleed air out of the system, park at the steepest incline you can find in your area. then just top it off to full, idle at 3000~ rpm for couple of minutes. let it go. let it cool off a bit, then do the same thing again.
after that, check and see if it has pressure (by removing the cap, remember, cover it with a piece of cloth b4 u do so in case the water splash around, u will not get burn)
is pretty easy to bleed air out of the system, park at the steepest incline you can find in your area. then just top it off to full, idle at 3000~ rpm for couple of minutes. let it go. let it cool off a bit, then do the same thing again.
after that, check and see if it has pressure (by removing the cap, remember, cover it with a piece of cloth b4 u do so in case the water splash around, u will not get burn)
When U mentioned to top it off, u meant like full at the resrevoir?
I do this all the time, or it has a "top full line"?
Tks
#53
I think My Cooling Fan #2 is running slower than it should, when its turning I can see the blur, and when I turn it with my hand, it feels kinda hard, just not as smooth as the Fan #1.maybe I should get a multimeter to test it.
when you were at Wayne Mazda, did you just tell them that "oh, my fan is broken" or what ?
when you were at Wayne Mazda, did you just tell them that "oh, my fan is broken" or what ?
Thread
Thread Starter
Forum
Replies
Last Post
GranTouTou
Series I Wheels, Tires, Brakes & Suspension
0
09-30-2015 06:11 AM
akagc
RX-8's For Sale/Wanted
7
08-11-2015 07:07 PM