Just like the topic saids.

I just installed the Defi Control Unit (Thx StealthTL!)

Now Im trying to find a *path* where I can squeeze 3 sensor wires thru the firewall without drilling a hole thru it ...

For Water Temp, Oil Temp, and Oil Press.

I have all the wires and oil filter block, just cant find any clear path

Can Anybody guide me to the light ?

 

Just follow the heater/a.c. hoses, dig a screwdriver thru the big rubber grommet.

....much easier from the engine side, easier still if you pull the washer bottle out.

S

 

OOOO

Im going to check it out RIGHT NOW

 

Im back

Well, my screwdriver probably too short or I got the wrong line.

I keep hitting walls, I probably did it wrong.

Im gonna keep digging ....

 

I found a rubber plug in the firewall, used a hot soldering iron and burned a hole thru it, ran the wires right thru that

 

Do you have a picture of the location ?

Im thinking my sensor will go 2 ways. Left side for Oil Press and Oil Temp, Right side for Water temp.

 

mine both ran thru the same hole

 

I will give it a shot tomorrow.

Might as well do a DIY for it. Cuz I think this will help lots of people. (Bro took my camera, god damn it)

 

^ post pics once you are done

 

Im Done :D

Spent another 3 hours on it. almost got myself killed in the process ...

Well, its working now.

Still waiting for my brother to come back with my camera.

 

pics

 

Dont worry man, I will post pics up :P

 

With my install, we ran all wires through a hole we drilled behind the windshield washer fluid resevoir. We placed a rubber grommet on the hole and its super stealth.

 

I route them thru the Hood release cable hole. No drilling needed.

but it was a *BITCH* get the the last cable into the hole cuz with 3 already in place (the hood cable and 2 sensor cables), the hole was kinda tight. :P

I just got the Oil Temp and Oil Press running, will finish the water part later the weekend.

 

forgot to post pics.

Oil Temp and Oil Press shown, Water temp coming soon (as soon as I get my new PUMP from Paul @ Mazmart )

The install looks kinda whack, I just use Epoxy to glue them on the dash. I will fix it up later.