Metra kit update (need cable? look here)
#403
#404
Need Webxxpress and USB bootloader software
Hi,
i have question if someone has Webxxpress and USB bootloader software. I try to update my metra kit but the new Axxess updater does not work.
Please could someone provide me this old software?
Thank you very much
i have question if someone has Webxxpress and USB bootloader software. I try to update my metra kit but the new Axxess updater does not work.
Please could someone provide me this old software?
Thank you very much
#406
Registered
Hello, 2024 :D
unfortunately, I was not able to get hold of Webxxpress to check but I know the cable is a basic USB TTL serial connector
What you need is multiple voltage generic cable or the cable at least supports 5V as well
use these pins :
1- Vcc + 5V
2- TTL Transmitter TX
3- TTL Receiver RX
4- GND
Pin 1 is the closet to the outside, the other sockets. For unknown reasons, the forum won't let me upload any photos today.
unfortunately, I was not able to get hold of Webxxpress to check but I know the cable is a basic USB TTL serial connector
What you need is multiple voltage generic cable or the cable at least supports 5V as well
use these pins :
1- Vcc + 5V
2- TTL Transmitter TX
3- TTL Receiver RX
4- GND
Pin 1 is the closet to the outside, the other sockets. For unknown reasons, the forum won't let me upload any photos today.
Last edited by motodenta; 04-07-2024 at 10:27 AM. Reason: try to upload photo
#407
Registered
For whatever reason I wasn't able to upload the photos from my macbook and had to use my windows laptop.
Maybe the major reason could be the age of my macbook pro as it is the same as the date on this metra pcb loll
Anyway, that's pin out in the correct order, I didn measure them via multimeter to check the right order.
fun fact ignoring the date on pcb the version in 2.0 has been on the serial number and as confirmed by holding mode selection on screen.
Maybe the major reason could be the age of my macbook pro as it is the same as the date on this metra pcb loll
Anyway, that's pin out in the correct order, I didn measure them via multimeter to check the right order.
fun fact ignoring the date on pcb the version in 2.0 has been on the serial number and as confirmed by holding mode selection on screen.
Last edited by motodenta; 04-07-2024 at 06:21 PM.
#408
Rotary Crawfish
Guys the last update to the Metra Axxess was a very long time ago. Look on the circuit board,if it is Rev F 20 which your sticker denotes, that was highest program.
The software doesn't work because you are already at the end.
I talked to a guy at Metra and he explained the last revision was around 2013-2014.
The software doesn't work because you are already at the end.
I talked to a guy at Metra and he explained the last revision was around 2013-2014.
Last edited by cajunrx8; 04-12-2024 at 11:53 AM. Reason: forgot something
Thread
Thread Starter
Forum
Replies
Last Post
axxess, bootloader, box, cable, installing, metra, metrakit, performance, port, problem, small, update, updater, usbcab, webxxpress